1436400 Craftsman - Overview

It is an authentic OEM sourced item which is specifically produced for use with snowthrowers and lawn mowers made by Tecumseh and Toro. The high speed bowl nut connects to the bowl nut washer and the carburetor bowl. During the installation process, a wrench set might be needed to replace this part. Over time this part may become stripped...Read more or broken and will need to be replaced. This item is priced individually and is made of metal.

This OEM valve cover gasket, also known as the breather gasket, creates a seal between the breather body and cylinder block in your lawn equipment. Made of flexible plastic, it measures 2 inches by 4 inches. Oil stains or leaks around the valve cover indicate a problem with the gasket. You may also notice a burning smell or ticking noise ...Read morefrom the engine. If the gasket is not replaced, it can lead to severe engine damage and even engine failure. When replacing the gasket, start by turning off your machine and disconnecting the spark plug. Depending on your equipment model and make, you may need to remove components like the air filter or spark plug wires to access the valve cover. Refer to your user manual for guidance. Once you have access to the valve cover, use a wrench or socket to unthread the securing bolts or screws. Then, carefully peel off the old gasket. Please keep in mind that this replacement part is sold individually.

It is a genuine gasket that is supplied directly from the original equipment manufacturer for use with lawn and garden equipment. This special gasket is utilized to provide an air-tight seal for the muffler, please make sure to check appropriate diagrams of your model for the correct location and application of this hardware. Over time th...Read moree material may wear out and begin to crack eventually requiring a replacement to ensure the proper seal. It is a high-quality component which is made of durable composite material, please note it is sold individually.

This spark plug cover is supplied directly from the original equipment manufacturer. The rubber and metal component is often used in snowthrower engines, and is sold individually. The spark plug cover is fitted over the spark plug wire connection, providing protection. A screwdriver and pliers may be required for the removal and replacement.

This is an original replacement part manufactured for use with small engines. This special fuel fitting is used to connect the fuel line to the carburetor. Overtime old fuel can clog passageways within the carburetor and may require the carburetor to be rebuilt. This fuel fitting is sold as an individual replacement part, please see model diagram for associative parts.

This O-ring is designed for use with small engine carburetors and is made of rubber, meaning over time and further exposure to fuel, it will become brittle and crack. This O-ring is installed within the carburetor and is located between securing screws near the base. If disassembling your equipment to replace this O-ring, it is recommende...Read mored you inspect the other parts to ensure optimal performance and to prevent any leaks. Featuring an inner-diameter of approximately 0.25-inches, the replacement process for this O-ring in your engine will vary, so check the user manual for exact location of this part.