143605 Craftsman Engine - Overview

This is a replacement cylinder head gasket for your small engine. It is approximately 5 inches in width and 6 inches in length. The cylinder head gasket helps to create a seal for the cylinder head. If you have oil leaking, or you hear a hissing sound when your engine is in use, you may have a blown head gasket. This part is sold individually and is an OEM part sourced directly from the manufacturer.

This is a genuine replacement part that has been sourced from the original manufacturer to be used with snow thrower engines from Husqvarna and Toro. The metal screw is used to fasten the fuel tank to the tank mounting bracket. This item is available as an individual replacement part, please note a hex socket wrench may be needed to install this item.

This OEM valve cover gasket, also known as the breather gasket, creates a seal between the breather body and cylinder block in your lawn equipment. Made of flexible plastic, it measures 2 inches by 4 inches. Oil stains or leaks around the valve cover indicate a problem with the gasket. You may also notice a burning smell or ticking noise ...Read morefrom the engine. If the gasket is not replaced, it can lead to severe engine damage and even engine failure. When replacing the gasket, start by turning off your machine and disconnecting the spark plug. Depending on your equipment model and make, you may need to remove components like the air filter or spark plug wires to access the valve cover. Refer to your user manual for guidance. Once you have access to the valve cover, use a wrench or socket to unthread the securing bolts or screws. Then, carefully peel off the old gasket. Please keep in mind that this replacement part is sold individually.

It is a genuine gasket that is supplied directly from the original equipment manufacturer for use with lawn and garden equipment. This special gasket is utilized to provide an air-tight seal for the muffler, please make sure to check appropriate diagrams of your model for the correct location and application of this hardware. Over time th...Read moree material may wear out and begin to crack eventually requiring a replacement to ensure the proper seal. It is a high-quality component which is made of durable composite material, please note it is sold individually.

This spark plug cover is supplied directly from the original equipment manufacturer. The rubber and metal component is often used in snowthrower engines, and is sold individually. The spark plug cover is fitted over the spark plug wire connection, providing protection. A screwdriver and pliers may be required for the removal and replacement.

This is an authentic part that is supplied directly from the original equipment manufacturer for Craftsman and Tecumseh pressure washers, lawn mowers, and snow blowers. When pulled, the starter rope engages starter spring causing the engine turn fast enough for the ignition module to generate a spark to ignite the fuel in the cylinder. Th...Read moreis part is made of nylon rope and is sold individually. To install the rope you will need a screwdriver and socket wrench. Turn the starter spring to build tension and recoil the rope inside.

This breather element is also called an air filter cartridge, cleaner element, or engine filter. It prevents debris from reaching the carburetor of your lawn equipment while allowing clean air to enter. This clean air-fuel mixture is essential for energy production. A broken or clogged breather element can lead to fuel flow issues, errati...Read morec operation, or starting difficulties. Neglecting to replace a damaged breather element can result in engine problems such as poor fuel combustion, reduced power, or engine stalling. To access the breather element, locate its housing on your machine using your instruction manual. Remove any necessary clips or screws with pliers or a screwdriver. You may also need to put oil on this breather element while installing it into your machine, according to instructions given by its manufacturer. This OEM-verified component is sold individually.

It is a genuine manufacturer-approved replacement part that is supplied for use with Tecumseh engines commonly installed on Toro and Husqvarna snowthrowers. This is the special screw which is used to secure the carburetor cover which protects the internal components from dust and other debris. It is a high-quality hardware which is made of durable metal and it is sold individually.