143584 Craftsman Engine - Overview

This item is available as an individual replacement part. The gasket attaches to the intake pipe and is made out of a thin material. During replacement, it may require a screwdriver to help install this part correctly. It will require replacing if it breaks. This genuine item is supplied by the original equipment manufacturer for use with...Read more lawn mowers, lawn tractors, and snowblowers made by Tecumseh, Toro, and Lawn Boy.

This is a genuine replacement part that has been sourced from the original manufacturer to be used with snow thrower engines from Husqvarna and Toro. The metal screw is used to fasten the fuel tank to the tank mounting bracket. This item is available as an individual replacement part, please note a hex socket wrench may be needed to install this item.

This part is available as an individual replacement. The extension spring attaches to the control. A screwdriver and a set of pliers might be needed during the installation process. This part is made out of metal and will need to be replaced if it bends or breaks. It is a genuine item that is supplied by the original equipment manufacture...Read morer for use with engines and snowblowers made by Tecumseh, Husqvarna, Toro, and Lawn Boy.

This spark plug cover is supplied directly from the original equipment manufacturer. The rubber and metal component is often used in snowthrower engines, and is sold individually. The spark plug cover is fitted over the spark plug wire connection, providing protection. A screwdriver and pliers may be required for the removal and replacement.

This is an authentic part that is supplied directly from the original equipment manufacturer for Craftsman and Tecumseh pressure washers, lawn mowers, and snow blowers. When pulled, the starter rope engages starter spring causing the engine turn fast enough for the ignition module to generate a spark to ignite the fuel in the cylinder. Th...Read moreis part is made of nylon rope and is sold individually. To install the rope you will need a screwdriver and socket wrench. Turn the starter spring to build tension and recoil the rope inside.

This spring-governor is an OEM part which is designed for Briggs and Stratton engines that are commonly installed on a variety of lawn and garden equipment. It applies tension on the governor. The governor system is like a cruise control system. It maintains the speed by adjusting the carburetor. Over time it may wear out and stretch even...Read moretually requiring a replacement. It is made of a high-quality metal and is sold as an individual component. Refer to the diagrams for your model for the exact location and the correct installation of this hardware.

This item has been sourced from the original manufacturer to be used with small engines from Briggs & Stratton. The float needle valve is used with the carburetor assembly. This item attaches to the float and allows fuel into the carburetor when the fuel is drained and stops the fuel when the bowl is full. This item is available as an individual replacement part.