1431-0 Craftsman Pressure Washer - Overview

Sourced directly from the manufacturer, this part is used to open and release hot water if the water exceeds the maximum operating temperature. It has metal and plastic components, is not part of a kit or assembly, and is sold individually. When malfunctioning, the Thermo Relief Valve will open on a regular basis, which can cause damage ...Read moreto your pump. If it is opening often or on a regular basis, replace it to protect your pump from damage. You will need a socket set, a wrench set, and pliers to complete this repair. Customers rate this repair as Easy.

This replacement part is used on the base of various models of pressure washers to reduce vibration from the pump. This Grommet has an O.D. of 1 inch, is not part of a kit or assembly, is sold individually, and is made of durable black rubber. This part is known to wear with regular use of your machine, it should be replaced if you noti...Read moreced more vibrations than normal within the unit. Customers rate this repair as Easy.

This bottle of oil can be used in over 150 different types of machinery. It is most commonly used for pressure washers and generators from manufacturers such as Briggs and Stratton and Troy-Bilt. This detergent oil is warranty approved and specially compounded for warm weather use. Please note: it is important to avoid over filling your engine with oil.

The authentic 10" Wheel Assembly (Wheel, 10" Diameter) is a 10-inch black, plastic-and-ubber wheel. It allows easy moving of the generator. Installation requires pliers and is rated as "Easy". If your tire is flat, then it should be replaced. Refer to your make, model and diagram to ensure this is the right part.

This is a genuine Briggs & Stratton replacement part. The oil seal is designed by the manufacturer for use in pressure washers. This part is placed in the crankcase to prevent inadvertent oil leakage. You may require a screwdriver or Allen wrench when replacing this item. This part is sold individually.

This replacement trigger gun assembly is specially designed for use with a variety of pressure washers. It is the essential part of the unit that allows user to direct and control the spray. Please note the wand and the hose are both sold separately. This pistol assembly is made out of plastic with metal fittings. This handle is only for pressure washers up to 3000-psi using M22 hose connector.

It is a genuine item that is supplied directly from the original equipment manufacturer for use with Briggs and Stratton generators and pressure washers. The purpose of this component is to reduce the vibration of a working unit, unfortunately, over time it may begin to fail eventually requiring a replacement. Please make sure to refer to...Read more the appropriate diagrams of your model for the correct location and application of this part. Keep in mind this high-quality vibe mount with a washer is sold individually.

This is an authentic component is sourced directly from the original equipment manufacturer. It is the part that is specially made for use with Briggs and Stratton and Snapper pressure washers. The purpose of this o-ring is to provide a tight seal between connected components. Unfortunately, over time it may wear out and begin to crack ev...Read moreentually requiring a replacement. Please make sure to check the owners manual and the diagrams of your model for the correct installation of this part. This high-quality o-ring is made of durable rubber and is sold individually.

This Chemical Hose Filter is a genuine replacement part for various models of pressure washers. It is made of durable blue plastic, is not part of a kit or assembly, is sold individually, and is used to prevent debris from being drawn into the pump. When this part is damaged or clogged, it can prevent the flow of water. This part can be...Read more removed and cleaned but will need to be replaced if it is worn or damaged. Customers rate this repair as Easy.