14-040A1 Frigidaire Dehumidifier - Overview

If the bucket is full indicator on your dehumidifier is on, but the bucket is empty, or your dehumidifier is overflowing, you may have a problem with the float. This device is located near the bucket and moves up as the water level in the bucket rises. The float will trip the water level switch when the bucket is full. This is a safety de...Read morevice to prevent the unit from overflowing. When the switch is tripped, power to the compressor and fan motor circuits is disrupted until the bucket is emptied. Make sure that the float assembly can move or pivot freely so that it can trigger the level switch when the bucket is full. If the assembly is warped or damaged it should be replaced.

This is a humidistat control for a dehumidifier. The humidistat on your dehumidifier responds to the humidity in the air to determine if the appliance should continue to dehumidify or shut off, based on the desired humidity level. This control needs to be replaced if the dehumidifier wont shut off when the desired humidity level is reache...Read mored. This part is approximately 3.5 inches long and 1.5 inches wide. The part will be easy to replace, simply remove the front cover, remove the humidistat from the bracket, and remove the two push-on wire connectors. Reverse this process to reinstall the control. Be sure to disconnect power to the dehumidifier before completing this repair.

This indicator light lens protects bulbs in ranges, ovens, stoves, and humidifiers. The lens keeps the bulb from getting cracked, scratched, and damaged. It is 1 inch long and 1 inch wide. If your lens is defective or broken, or the bulb is easily getting damaged, replacing the lens can be a solution. Refer to the installation instruction...Read mores provided by the manufacturer for further accurate guidance. Remember to unplug your appliance from the power source before starting this project and wear gloves to ensure your hands are protected.

The auto shut off switch is for dehumidifiers. If the water bucket is not attached properly the switch will ensure the compressor does not run. You may need to perform a continuity test on the switch to determine if the part has indeed failed since you cannot tell by looking at it. Make sure your dehumidifier is unplugged before you begin...Read more. Consider wearing gloves to protect your hands while performing this task. This is a genuine OEM part that comes straight from the manufacturer.