14-040 (Type 1) Delta Drill Press - Overview

Stiff movement, poor bit grip, or a seized chuck can make a drill press difficult or unsafe to use. This replacement chuck and key assembly holds drill bits firmly while the spindle turns. Check for dirty jaws, an incorrect key, bent bits, spindle runout, and worn bearings before deciding the chuck has failed. Match the replacement to the...Read more full tool model and type because similar-looking chucks may use different mounting systems. Disconnect electrical power before service. Use the correct removal tool, protect the chuck from falling, and clean the spindle and chuck socket thoroughly. Do not oil the mating surfaces. After installation, check bit alignment and operation at low speed.

This is a genuine OEM replacement part, it is sold individually. This Key is needed to operate all of the models listed below. It is inserted into the switch to make it possible for the machine to turn on. It can be removed for the purpose of unauthorized use of the machine.

It is an authentic OEM sourced item which is specifically produced for use with drills made by Delta and Black & Decker. The pin is made of metal and attaches to the table. During the installation process, a socket set might be needed to replace this part. It may become broken or bent and will need to be replaced. This is available as an individual replacement part.

This is a genuine Delta crank handle which is found on many drill press models. It will directly replace a worn, broken or missing handle. Please note that this handle does include the set screw for securing it in place. The handle will fit the Delta drill press models listed in the section below, but it is not guaranteed to fit any other tools.

Genuine Delta replacement part, this part with 2 part. The Delta 1310082 Spring With Housing is the part of the drill presses listed below that returns the drill chuck back to its original position after using the drill press. This part contains the spring and the spring housing.

This is a genuine OEM replacement part designed for use with a variety of power tools. It is made out of metal and it is sold individually. It is a standard hardware which has multiple applications based on your tool. You would need a wrench to tighten/loosen this nut.

This genuine manufacturer-supplied outlet box cover is designed for Delta drill presses. It is an identical replacement for a missing or a damaged part that was installed on a new equipment. Refer to the diagrams for your specific model to ensure the exact location and the correct repair procedure. Keep in mind this high-quality cover is made of durable material and is sold as an individual item.