126-262-059 MTD Lawn Mower - Overview

This cable barrel holder is a genuine OEM part that is designed for use with tillers and snow throwers. Sold as an individual part, this holder measures approximately 1-inch in length and is used to secure the clutch control handle and cable together. This holder is made of durable plastic and can replace the old holder by simply removing...Read more it, inserting the cable into the new holder, and tightening it until it is locked in place.?

This silver metal lock washer helps prevent the nut on the drive belt pulley shaft from backing off during operation, it has a 5/16-inch inner diameter and a 1/2-inch outer diameter. one washer is included, replace it if fatigue or damage allows the connected shafts to spin freely, verify fit using the equipment model or owner manual

This is a genuine OEM sourced replacement screw which is commonly utilized on lawn and garden equipment. It is a standard hardware which has multiple applications based on the model of your unit, please refer to appropriate diagrams for the correct location and use of this part. It is a high-quality hex head screw which is made of durable...Read more metal and it is sold individually. Over time threads may wear out or it may simply get lost eventually requiring a replacement, note that a wrench will be needed to install or remove this hardware.

This is an authentic MTD tiller replacement part. The hex B-tap screw is used to fasten the cable barrel holder to the clutch lever to ensure good tension on the clutch cable. The part is made of durable metal. You will need a wrench to replace this piece. This item is sold individually.

This Bell-Wash Flat Washer is an OEM part that measures .40 inches I.D. x 88 inches O.D. This washer is a silver, metal, washer sold individually. This part is rated as Easy to install by customers. If missing or damaged (likely due to fatigue) it should be replaced. Refer to your owners manual to ensure this is the correct part for you.

This is an original Craftsman replacement part. The carriage screw is designed by the manufacturer for use in snowblowers and lawn tractors. This part is made of metal, and may be found in various locations in the machine, depending on model. Please be aware that there are different screws used in the machine. Refer to the parts diagr...Read moream to be sure of ordering the correct part. You will require a wrench when replacing this item. This part is sold individually.

This OEM Hex Nut 5/16-24 is a silver, metal nut. This certified part is sold individually. It can be applied with a Wrench or Socket and Torque Wrench to the bracket on the rear of the auger house to secure a bracket to the back of the auger housing. Simply torque to the manufacturer specifications. Refer to your owners manual to find o...Read moreut if this is the part you need. Over time the part may be damaged by fatigue and will come loose due to damaged threads, at which time it should be replaced.

This OEM Hex Nut is a gold colored, metal, 3/8 x 16 part, sold individually. It is installed with a wrench, or socket and torque wrench, by torquing to the manufacturer specfications, and is used to secure parts in place. You will know it is broken when you see the nut has damaged threads or rounded off edges, which can happen due to fa...Read moretgiue. If it is damaged, it should be replaced. This part can have different uses and different degrees of difficulty depending on the part the hex nut is securing, but generally the replacement of this part is an easy job.