122LK (967252801) Husqvarna Trimmer - Overview

The Starter Pawl bridge provides the resistance needed for the starter rope to start the trimming engine. It is an OEM part that attaches inside the recoil assembly. If broken due to weaar or fatigue, the engine will not engaged when the rope is pulled, and the part should be replaced. Installation is rated as easy and requires a screwdrv...Read moreier, pliers and nutdriver. Refer to your make, model and diagram to check if this part is correct. This part is metal, individually sold, and comes in gold.

This is a genuine part that is supplied by the original manufacturer for use with Husqvarna and Jonsered trimmers and edges. The air filter cleans the air entering and exiting the carburetor. This part is a common wear item, we recommend replacing the air filter periodically. For this repair, you will need a pair of pliers and a screwdriv...Read moreer to remove any covers or shrouds. Be sure to unplug the spark plug and boot wire before starting this repair.

This is an authentic OEM part from Husqvarna for use with Line Trimmers. The recoil starter assembly spins the flywheel to start the engine. This assembly includes the recoil starter cover. The most common reason for replacing the starter assembly is if it is damaged or will not start the engine properly. This part is sold individually. T...Read morehe tool that you will need to replace the starter assembly is a T-25 Torx head screwdriver.

This is a standard hardware which has multiple applications based on your tool. It is sourced from original equipment manufacturer for use with a variety of power equipment. Please refer to diagrams for proper application. This screw is made out of metal and it is sold individually. Requires a hex key or an allen wrench to install or remove it.

This item has been OEM sourced to ensure a high level of quality. The gearbox assembly is intended to be used with trimmers from Husqvarna and Jonsered. The gearbox attaches to the bottom of the lower drive shaft. This item is used to connect the rotation of the shaft with the rotation of the cutting head. This gearbox is sold as an individual replacement part.

This shield kit is an original replacement part manufactured for use with brushcutters, and trimmers. The plastic shield comes in the distinctive Husqvarna orange color and is used to protect from debris that is shot out while operating the trimming equipment. The shield assembly is complete including the mounting hardware, and a blade that trims excess trimmer line. The shield kit is sold individually.

This is a genuine manufacturer-sourced replacement part which is specially designed for use with Husqvarna lawn and garden equipment. It is an identical replacement for a missing or damaged hexagon nut that was installed on a new unit. This is a standard hardware which has multiple applications, please make sure to refer to the appropriat...Read moree diagrams of your model for the correct location and application of this component. Keep in mind this high-quality nut is made of durable metal and is sold individually.

This resistor spark plug is a genuine OEM replacement designed for small, handheld outdoor power equipment. It delivers reliable ignition for 2-stroke engines, helping support smooth starting, stable idling, and consistent performance during operation. Built to reduce electrical interference and withstand regular use, it’s an ideal choice...Read more for routine maintenance or replacement when misfires, hard starting, or power loss occur.

This is a genuine part which is supplied directly by the original equipment manufacturer and is used with Husqvarna and Jonsered hedge trimmers. The fuel filter removes debris before it reaches the carburetor in your gas-powered equipment. This part made of metal and is sold individually. For installation, you will need a socket wrench to remove any shrouds or panels, and a pair of needle nose pliers to aid you.

This is an authentic replacement part manufactured for use with Husqvarna brushcutters and trimmers. The driver assembly fits on the bottom of the gear case and is used to cover the spindle and bearings. This driver assembly is sold as an individual replacement part.