12212 Troy-Bilt Tiller - Overview

This OEM Wheel Shaft Oil Seal is a black rubber part which attaches to the drive shaft to prevent leaks between the wheel shaft and transmission case. Installation is rated as "Medium" difficulty and requires a Screwdriver, Hammer, Washer, and Pipe to fit in the seal. If broken due to damage/fatigue, there will be a leak and the part shou...Read moreld be replaced. Refer to your make, model, and diagrams to ensure this is the right part for you.

This Washer-Lock 5/16 is a silver metal part that is sold individually and comes direct from the manufacturer. With a 5/16 Inch Interior Diameter and 1/2 Inch Outside Diameter it is used to prevent the nut from backing off and becoming loose on the pulley shaft and is attached to the drive belt pulley assembly. You will know if you need t...Read morehis because your owners manual will specify it or the model number of your machine will correspond with this part. If the part is broken due to fatigue the shafts will free spin when they should be locked together and must be replaced.

This OEM Forward Idler Pulley attaches to the pivot bracket to allow the forward belt to idle when not in forward motion. If broken, the machine will no longer be able to propel forward, and the part must be replaced. This part is rated as "Easy" to install by customerss, and requires a wrench set. It is individually sold, and constructed...Read more of metal. Refer to your make, model and diagrams to ensure this is the right part.

It is a genuine item that is supplied directly from the original equipment manufacturer for use with Troy-Bilt and MTD lawn and garden equipment. This is a special component that is utilized to provide a tight seal between connected components, please make sure to refer to the appropriate diagrams of your model for the correct location an...Read mored application of this part. Keep in mind it is a high-quality part which is made of durable metal and is sold individually.

This is an authentic Troy-Bilt replacement part that has been sourced from the original manufacturer to be used with tillers. The knob attaches to the end of the depth regulator bar and is used to provide a grip to the bar when changing the depth of cut. This item is available as an individual replacement part.

This OEM 5 Pin ignition Switch is a silver, steel, individually sold part. It can be installed using a wrench and screwdriver, and has been rated as Easy to install. The part attaches to the dashboard, and is used to start and shut off the engine. If it is broken (likely due to fatigue), you will no longer be able to start or stop your ...Read moreengine and the part must be replaced. Refer to your owners manual or model number to ensure you are purchasing the correct part.

This is a genuine manufacturer-sourced component which is specially made for use with Troy-Bilt tillers. It is an identical replacement for a missing or a faulty bolo tine that was installed on a new unit. Soil conditions are important for proper tilling. Tines will not readily penetrate dry, hard soil which may contribute to excessive bo...Read moreunce and difficult handling of your tiller. Please make sure to refer to the owner's manual and the appropriate diagrams of your model for the correct location and application of this part. Keep in mind this high-quality tine is made of durable metal and is sold individually.

This pair of keys is supplied by the equipment manufacturer for use in lawn and outdoor power equipment. The key is made of metal and designed to prevent unauthorized use or accidental starting of the equipment. It is fitted into the ignition switch, found near the operator seat or control panel. If the key is lost, damaged, corroded or w...Read moreorn down, you will not be able to engage and start the engine. These keys come in a set of two.