12164 (121641100101-121641199999) Troy-Bilt Tiller - Overview

This is an original replacement part sourced directly from the manufacturer. The screw is commonly found in yard equipment from Craftsman, such as lawn tractors, snow blowers, and edgers. This part is made of metal, and may be found in various locations in the machine, depending on model. Please be aware that there are different screws...Read more used in the machine. Refer to the parts diagram to be sure of ordering the correct part. You will require a wrench when replacing this item. The screw is sold as an individual replacement part.

This OEM Wheel Shaft Oil Seal is a black rubber part which attaches to the drive shaft to prevent leaks between the wheel shaft and transmission case. Installation is rated as "Medium" difficulty and requires a Screwdriver, Hammer, Washer, and Pipe to fit in the seal. If broken due to damage/fatigue, there will be a leak and the part shou...Read moreld be replaced. Refer to your make, model, and diagrams to ensure this is the right part for you.

This silver metal lock washer helps prevent the nut on the drive belt pulley shaft from backing off during operation, it has a 5/16-inch inner diameter and a 1/2-inch outer diameter. one washer is included, replace it if fatigue or damage allows the connected shafts to spin freely, verify fit using the equipment model or owner manual

This is a genuine OEM sourced item that is specially produced for Troy-Bilt and MTD roto-tillers. The purpose of this component is to provide a tight seal which will prevent oil from leaking. It is an identical replacement for a missing or worn seal-oil for the tine shaft that was originally installed on a new unit, please make sure to ch...Read moreeck the appropriate diagrams of your model for the correct location and application of this hardware. Keep in mind this high-quality item is made of durable metal and is sold individually.

This OEM Forward Idler Pulley attaches to the pivot bracket to allow the forward belt to idle when not in forward motion. If broken, the machine will no longer be able to propel forward, and the part must be replaced. This part is rated as "Easy" to install by customerss, and requires a wrench set. It is individually sold, and constructed...Read more of metal. Refer to your make, model and diagrams to ensure this is the right part.

It is a genuine item that is supplied directly from the original equipment manufacturer for use with Troy-Bilt and MTD lawn and garden equipment. This is a special component that is utilized to provide a tight seal between connected components, please make sure to refer to the appropriate diagrams of your model for the correct location an...Read mored application of this part. Keep in mind it is a high-quality part which is made of durable metal and is sold individually.

This is an authentic Troy-Bilt replacement part that has been sourced from the original manufacturer to be used with tillers. The knob attaches to the end of the depth regulator bar and is used to provide a grip to the bar when changing the depth of cut. This item is available as an individual replacement part.

This is a genuine manufacturer-sourced component which is specially made for use with Troy-Bilt tillers. It is an identical replacement for a missing or a faulty bolo tine that was installed on a new unit. Soil conditions are important for proper tilling. Tines will not readily penetrate dry, hard soil which may contribute to excessive bo...Read moreunce and difficult handling of your tiller. Please make sure to refer to the owner's manual and the appropriate diagrams of your model for the correct location and application of this part. Keep in mind this high-quality tine is made of durable metal and is sold individually.