Quick Question!

Have you ever purchased from PartSelect.com before?

Models > 12-2299-00-01

12-2299-00-01 Tappan Wall Oven - Overview

Get Parts and Repair Help for 12-2299-00-01

If you know the wall oven repair part you need, you can browse the list of all parts on the 12-2299-00-01, or you can search by name or part description. You can also find your part by where it is located on the 12-2299-00-01 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your wall oven. We’ve also included any installation videos we have for 12-2299-00-01 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$30.49

Flat Style Oven Igniter

This is a flat style oven igniter used to light the element in a gas range. When the element in this igniter glows white hot, the gas is released from the safety valves, which ligh...

$23.65

Light Bulb Lens

The Frigidaire light bulb lens covers the interior light bulb in an oven. No tools are necessary to replace this item. After unplugging the appliance, slide off the wire bracket to remove the existing light bulb lens. Be sure to remove all broken glass, if applicable, before installing the new lens. It is recommended to check the state of the light bulb while the lens is off. This part is made of glass. The lens is a genuine Frigidaire part, sourced directly from the manufacturer, and is sold individually.

$30.10

Oven Light Socket

The oven light socket allows you to screw in a light bulb so that you can see the inside of your oven. The light socket is located in the back of your oven, so you will need to rem...

$9.73

LAMP

$35.45

Rack

$35.52

Light Lens Retainer Clip

This is a light lens retainer clip and it is used in conjunction with the oven on your range. This retainer clip secures the light lens to the oven cavity. The part is made entirely of metal, and it is thin and bow-shaped. The retainer clip is roughly 3.5 inches long and 2 inches wide. The most common reason for needing to replace this part is if your current one is damaged or missing. This clip is a genuine OEM piece sourced directly from the manufacturer.

$81.34

Oven Door Seal with Metal Clips

This part is an oven door seal with metal clips. It may also be known as a gasket and it is a part for the oven in your range. This gasket comes with ten clips and is black in colo...

$80.44

Exterior Drawer Glass - Black

$121.96

Outer Oven Door Glass - Black

$100.12

TRIM

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Oven quit heating.

  • Customer: John from Darlington, SC
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver
  • 512 of 555 people found this instruction helpful
After reading up on the problem of the gas oven not lighting I decided I needed to install a new igniter. I had read where some people just pulled a panel off the back and installed a new one.. yeah, no such luck with this model so I had to crawl into the broiler drawer space [which I had to clean out first]. Note, if you wear trifocal glasses you might as ... read more

Oven was difficult to light, then stopped lighting altogether

  • Customer: Ritchie from Ithaca, NY
  • Difficulty: A Bit Difficult
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Pliers, Screw drivers
  • 257 of 338 people found this instruction helpful
1. Turned off circuit breaker to stove
2. Removed the two screws holding down the floor of the oven (screws are at back.), and then lifted it out.
3. Removed the nut holding down the flame guard, and lifted it off.
4. Opened the bottom drawer.
5. Removed the protective cover in the back left of the oven at the bottom, first removing the ... read more

Oven Would Not Heat - Oven Ignitor Failure

  • Customer: Peter from Fife Lake, MI
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 140 of 211 people found this instruction helpful
I first looked up my Model Number on PartSelect.com and looked at the schematic as well as Trouble Shooted my problem.

Reading the posts by others how they Removed, Replaced, and Repaired their Oven Ignitors, I used their helpful info, and of course did mine.

1. Unplugged my Oven/Stove.

2. Removed bottom storage door to ge... read more