1187 (Type 100) Black and Decker Electric Drill - Overview

Length: 8' Gauge: 18 Wires: 2 Type: Bare Wire This cord is a genuine DeWalt replacement part. This cord is compatible with the list of models below. This part is made for double insulated tools It is a two wire cord with two prongs and does not need a ground wire. The cord is sold individually. Installation of this part requires the...Read more new cord wires to go correctly into wire terminals also routing the cord and wires in the right path can help avoid pinching when the tool case (Plate) is put back into place.

This is a genuine OEM replacement part, it is sold individually. This part is used to keep the brush tight against the armature so the tool will work properly. Over time when the brushes wear down and heat is created, the spring may lose its tension and will have to be replaced.

This screw is a genuine Dewalt chuck screw. It is constructed of tough steel for long life. It has a beveled head with torx drive for a secure fit. This screw is reverse thread for securing drill chucks. It also has locking compound within the threads for an even tighter installation. This screw is commonly found in Dewalt cordless...Read more drills and it is compatible with the tools listed below. It is not guaranteed to fit any other power tools.

This is an OEM sourced replacement part which is specially designed for use with DeWALT and Black and Decker drills. It allows user to secure drill bits. The ratcheting action clicks the jaws tightly into place for reduced bit slippage. If your drill's bit retention is suffering, the rotation feels stiff, or the chuck has seized up entire...Read morely, a new chuck should fix the problem. NOTE: This 3/8" capacity chuck mounts to the drill using a 1/2"-20 threaded spindle. The light-weight plastic design provides comfort while the keyless two-sleeve construction adds the efficiency and ease-of-use of keyless bit-swapping. See our post on Removing a Cordless Drill Chuck if you need help replacing your old chuck.

Genuine OEM replacement part, this item is sold individually. This screw is used in various places in all of the tools listed below The most common use for this screw is to secure plastic housings together. It has a Torx T-20 head.

This genuine cord protector, also known as a strain relief boot, is designed to safeguard the power cord where it enters your tool housing. Made from flexible, durable material, it helps prevent the cord from bending, twisting, or fraying during regular use, supporting safe and reliable performance. Small but essential, this component is ...Read morean effective replacement if the original protector is worn or damaged, helping extend the life of your tool and maintain proper cord alignment.

Genuine DeWalt replacement part. rnIncludes 1 Carbon Brush with wire lead in rubber sheath attached.rnrn • Worn brushes are frequently the cause of a poorly running motor. • Replacing brushes can fix an intermittently operating motor. • New brushes can restore a motor's electric braking. Carbon motor brushes are one of the most...Read more commonly replaced power tool parts. The reason is that carbon brushes are wear items, meaning that through friction and use they will gradually wear away and eventually will need replacing. Worn brushes are a common causes of intermittent motor function, reduced electric braking and reduced motor power. A worn-out brush will often be worn down near to the wire lead and can be cracked, pitted, or burned. When replacing carbon brushes, also check your armature for burns, cracks, or other damage which are indications of a larger motor problem needing attention.