1106202310 Kenmore Washer - Overview

The hose clamp is used to hold the water hose in place which will prevent the hose from leaking water. Sometimes the clamp may lose its ability to latch on, causing a leaking washer. For the installation, you will need a flat head screw driver to replace the clamp and a drill to access the screws to remove the front of the washer. Be care...Read moreful if you do not have specific clamp pliers as the clamp could fly off. Once the front of the washer has been removed, take a quick look for water damage or any obvious signs of where the leak is coming from. If it is not obvious, run water to test.

This speed governor, or clutch, can typically be found in your tilt-head or bowl-lift mixers beside the control plate. It is one of the three parts that work together to regulate and control the mixing speed. If you notice speed fluctuations or unresponsiveness to adjustments, the speed governor may be malfunctioning. To replace it, consu...Read morelt your user manual for instructions. Start by disconnecting the mixer from its power source and removing the beater and bowl. Take off the rear cover and unscrew the mounting screws from the trim to remove it. Disconnect the wires on the control plate and pry the end seal from the appliance. Remove the fasteners on the control plate to access the governor, which can be wiggled off the shaft using pliers. Please be aware that this OEM part is sold individually.

Sold individually.