This washer lid switch is a critical safety component designed to halt the spinning motion of the tub when the lid is opened. Its primary function is to prevent accidental contact with moving parts during operation, reducing the risk of injury. The switch activates automatically, interrupting the spin cycle as soon as the lid is lifted. I...Read moref the switch becomes faulty, the washer may not spin or may continue spinning with the lid open, posing a safety hazard. Replacement is recommended if the switch is damaged or no longer functioning properly.
This part is the replacement lid latch or latch assembly for your top-load washer. The lid latch holds your washer door closed, and allows the washer to run its cycle. If the lid latch is damaged, your washer door may not close properly and you may not be able to run your washer. The latch is found under the lid and can be screwed out and...Read more replaced. You will need a Phillips-head screwdriver for this repair. This part is sold individually and is and OEM part from the manufacturer.
See how others fixed this model. Time, tools, difficulty, and steps that lead to victory!View More
Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Defective lid latch - Cabrio Washer
97 of 124 peoplefound this instruction helpful.
William from Wakefield, RI
Very Easy
15 - 30 mins
Nutdriver, Screw drivers
The instructions that came with the part were worthless. Essentially, unplug, put in new part, plug it back in. I spent a considerable amount of time on the internet and finally found a video showing how to open the top. Unlike other models, it is held down by clamps in the back rather than clips in the front. Once finding this inform
... Read moreation the installation was simple. Remove the clamps and the back of the console, slide the top forward and lift, remove and replace the lock and reassemble. You don't even have to remove the hoses.
Read less
Was this helpful?
Thank you for voting!
Lid would not register closed washer would not spin
30 of 38 peoplefound this instruction helpful.
william from HOLLEY, NY
Really Easy
30 - 60 mins
Pliers, Screw drivers
Remove top of washer 5min R&R cable 20 min total time 25 min.
Was this helpful?
Thank you for voting!
Lid safety switch defective . Lid would not lock allowing washer operation.
19 of 21 peoplefound this instruction helpful.
Garry from CANON CITY, CO
Easy
30 - 60 mins
Screw drivers, Socket set
Remove small screws on back of top on both sides, slide top forward. No need to remove water hoses. Lift top up to expose switch safety mechanism (black plastic) on front underside of top. Undo screws holding switch mechanism. remove plate cover from back of top and unplug wiring harness. Thread new wireing harness and plug through hole
... Read morein top and plug in to plug receptor.