10K2750 Dotco Angle Grinder - Overview

This authentic manufacturer approved replacement rotor blade is designed for use with Cleco and Dotco power tools. It fits in the rotor helping to push the air inside the tool. Depending on your equipment you may need more than one (1) of these blades. This part is made out of composite material and it is sold individually.

This is a genuine manufacturer-approved gear lube that is specially produced for use with Cleco and Dotco sanders and grinders. It helps to lubricate the system allowing for easy movement and protecting the parts from the usual wear. Keep in mind this high-quality 2 oz. tube is sold individually. Please make sure to refer to the owners manual of your tool for the correct application.

The lube gun attaches to the gear lube. It is made of plastic and metal and is sold individually. This genuine item is supplied by the original equipment manufacturer for use with drills, grinders, sanders, and saws made by Dotco and Cleco. Over time this part may break and will need to be replaced.

This is an authentic Dotco replacement part that has been sourced from the original manufacturer to be used with pneumatic grinders, sanders, and saws. The steel bearing is used to reduce friction between a rotating shaft and a fixed part assembly. This bearing is available as an individual replacement part.

This authentic manufacturer-sourced component is specially designed for Cleco and Dotco tools. It is an identical replacement for a missing or a faulty hardware that was installed on a new unit. Check the appropriate diagrams for your model for the exact location and the correct application of this pin. Keep in mind this high-quality comp...Read moreonent is made of durable metal and is sold individually. Pliers might be needed to secure or remove it.

This is an authentic Cleco replacement part. The grease fitting is found on a variety of power tools from Cleco and Dotco, such as clutches and sanders. This is a metal part that is fitted to the housing to allow lubricant to be fed into bearings or gears using a grease gun. This part is sold individually.