1069552921 Kenmore Refrigerator - Parts

Sold individually.

This ice auger support, also known as a baffle, is a manufacturer-approved replacement part for your refrigerator ice maker. This part can become cracked or damaged, preventing your ice auger from doing its job. This repair requires extensive disassembly; take photos as you go to make reassembly easier. To replace this part, life the ice ...Read moredoor out of the way and life the ice arm into the off position. Pull out the ice bucket and use a 1/4 inch nut driver to remove the screws holding the ice container and connecting rod in place. Pry the e-clip and washer off the bottom of the auger assembly. Use a 9/16ths wrench to remove the nut at the bottom of the auger. Pull off the auger teeth assembly and replace the auger support with your new part. Now you can begin reassembling.

This part attaches to the drive shaft of the ice dispenser motor.

Sold Individually - Appliance originally takes 2.

This part includes 2 shelf support studs.

This refrigerator door hinge kit is a genuine OEM replacement designed to support the lower hinges of both the freezer and refrigerator doors. Engineered for durability and precision, it ensures smooth door movement, proper alignment, and a secure seal—critical for maintaining temperature stability and energy efficiency. The kit includes ...Read moreboth left and right lower hinges and is compatible with a wide range of models across Whirlpool and affiliated brands. Common symptoms indicating the need for replacement include difficulty opening or closing doors, poor sealing, excessive noise from the hinge area, and misalignment. Installation may require basic tools and should be performed with the appliance powered off.

This water inlet valve is for the ice maker and water dispenser in the refrigerator. To remove outlet tubing, depress ring that the tube slides into. Please remember to disconnect the power and water supply to the refrigerator before starting the repair.

Appliance spray paint is a great way to cover up any chips and scratches that have appeared on your appliances. Instead of replacing the part entirely, this is an easy fix. This is also a great way to give a fresh new look to any handles or areas that have discoloring due to wear. Make sure to clean the area before you begin and wear a pr...Read moreotective mask for safety. Give the can a good shake and spray a few inches away from the surface. Apply the paint until the area is fully covered as desired. Wait until the paint has dried before using the appliance.

This clip is sold individually.

This kit no longer includes the connectors. It is only the tubing/water reservoir. Note: This tubing requires an adapter coupler (PS369735) to take the tubing from 1/4 inch to 5/16 inch.

This kickplate grille is attached to the bottom of the refrigerator.

11-16 x 3/4 Sold individually.