1067-0 Briggs and Stratton Pressure Washer - Overview

Sourced directly from the manufacturer, this part is used to open and release hot water if the water exceeds the maximum operating temperature. It has metal and plastic components, is not part of a kit or assembly, and is sold individually. When malfunctioning, the Thermo Relief Valve will open on a regular basis, which can cause damage ...Read moreto your pump. If it is opening often or on a regular basis, replace it to protect your pump from damage. You will need a socket set, a wrench set, and pliers to complete this repair. Customers rate this repair as Easy.

Pressure washer pump kit. If the pressure washer is leaking water, the pump may need to be rebuilt or replaced. If the pump is more than a few years old, and you use the pressure washer fairly often, replace the pump.

This is an original replacement part sourced directly from the manufacturer. The unloader kit is commonly found in pressure washers from Briggs & Stratton. This part includes a plug made of high-quality plastic, a metal valve and spring, and two flexible rubber O-rings. You may require a wrench when replacing these parts.

The OEM vibration mount is a black rubber part, which is used to prevent vibrations between the frame of the generator and the floor. It can be installed with a screw driver,and its installation is rated as "Easy" by customers. It is installed on the bottom of the frame, facing the ground. If broken due to general wear/fatigue, there will...Read more be a noticeable vibration and the part may be tilted to one side. If this happens, the part should be replaced. Refer to your model, make and diagram in order to ensure this is the correct part.

This is a genuine Briggs & Stratton replacement part. The oil seal is designed by the manufacturer for use in pressure washers. This part is placed in the crankcase to prevent inadvertent oil leakage. You may require a screwdriver or Allen wrench when replacing this item. This part is sold individually.

It is an authentic item that is supplied directly from the original equipment manufacturer for use with Briggs and Stratton and Troy-Bilt equipment. This is an identical replacement for a missing or a faulty push nut that was installed on a new unit, please make sure to refer to the appropriate diagrams of your model for the correct locat...Read moreion and application of this component. Keep in mind this high-quality push nut is made of durable plastic with metal and is sold in a pack of two.

This authentic item is supplied directly from the original equipment manufacturer for use with generators and pressure washers made by Briggs & Stratton. The seal goes between the pilot spacer and the spacer plate. A set of pliers and a wrench may be necessary during the installation of this part. It may become broken and will need to be ...Read morereplaced. This item is made of hard rubber and is available as an individual replacement part.

This is an authentic component is sourced directly from the original equipment manufacturer. It is the part that is specially made for use with Briggs and Stratton and Snapper pressure washers. The purpose of this o-ring is to provide a tight seal between connected components. Unfortunately, over time it may wear out and begin to crack ev...Read moreentually requiring a replacement. Please make sure to check the owners manual and the diagrams of your model for the correct installation of this part. This high-quality o-ring is made of durable rubber and is sold individually.