10618 - Overview

This flat metal washer fits onto the speed guide-selector and is available individually. Please note that more than one washer may be needed when replacing parts. It will need to be replaced if it becomes lost or broken and may require a wrench during installation. This is an OEM Toro part sourced directly from the manufacturer and used in snowthrowers.

This handle is an original replacement part supplied by the manufacturer. It is commonly used in Campbell Hausfeld air compressors. It is compatible with over 150 models. This handle is attached to the top of the tank (part AR040500CG). A screwdriver is needed to remove and replace the screws that secure this part.

This is a genuine Toro replacement part that has been sourced from the original manufacturer to be used with snowthrowers. The metal flat washer is used to disperse pressure put on a part assembly by a nut or bolt across a wider surface area. This item is used with several different models of snowthrowers. It is recommended to review your...Read more model\\\'s part diagram to confirm the washer\\\'s compatibility and usage. The flat washer is priced individually.

This is an authentic Toro replacement part, sourced from the original manufacturer for use with snowthrowers. The metal washer is commonly used to disperse pressure put on the auger housing by the nut that fastens the chute retainer across a wider surface area. This bolt is sold individually.

This is an authentic Toro replacement part, sourced from the original manufacturer for use with outdoor power equipment. The woodruff key is used to link a shaft and pulley or gear to allow the either the pulley or gear to rotate along with the shaft. This woodruff key is available as an individual replacement part.

This is a genuine Toro replacement part. The lock washer is designed by the manufacturer for use in snow throwers. This part is made of metal, and may be found in various locations in the machine, depending on model. Please be aware that there are different washers used in the machine. Refer to the parts diagram to be sure of ordering...Read more the correct part. You will require a wrench when replacing this item. This part is sold individually.

This part is an OEM from Campbell Hausfeld for use with Air Compressors. The check valve lets pressurized airflow into the tank and prevents air from flowing back into the pump. The most common reason for replacing the check valve is if it is stuck open. This part is sold individually. The tools that you will need to replace the check valve is an adjustable wrench and a 7/16 wrench.

This is an authentic Craftsman replacement part, sourced from the original manufacturer for use with air compressors. The hex head screw is used to secure the motor assembly to the bracket on the tank of the compressor. These screws are sold in packs of eight pieces and the packs are sold individually.

It is a genuine item that is supplied by the original equipment manufacturer for use with Craftsman equipment. This is a high-quality replacement for a missing or a damaged o-ring which provides an air-tight seal between connected parts. Please make sure to refer to the appropriate diagrams of your model for the correct location and appli...Read morecation of this component. Keep in mind it is made of high-quality rubber and is sold in a pack of eight.

This is sold as a set that contains eight washers. These parts attach to the tank and are made out of metal. They are genuine items that are supplied by the original equipment manufacturer for use with Craftsman air compressors. During replacement, it may require a wrench to help install these parts correctly. They will require replacing if they become bent or broken.