1040-2 Briggs and Stratton Pressure Washer - Overview

This item is an authentic OEM sourced O-ring kit that replaces worn or damaged O-rings for the gun, hose and wand.Unfortunately, over time o-rings will wear out and they may begin to crack eventually requiring replacements. Refer to the appropriate diagrams for your model to ensure the correct replacement procedure. A screwdriver and a wr...Read moreench set might be needed to take apart and reassemble the equipment. Note, this kit is sold as an individual item.

This flat washer is an OEM part that is silver in color, made of metal, and its job in your equipment is to spread load and pressure under a bolt. It can have multiple uses depending on your equipment, and can be used in a lot of different equipment, so be sure to consult your owners manual or check your part number to ensure this fits yo...Read moreur model. Over time the washer may become damaged; watch for cupping from over-tightening as a leading cause. This is a very easy part to repair and does not require any tools.

This replacement part is used on the base of various models of pressure washers to reduce vibration from the pump. This Grommet has an O.D. of 1 inch, is not part of a kit or assembly, is sold individually, and is made of durable black rubber. This part is known to wear with regular use of your machine, it should be replaced if you noti...Read moreced more vibrations than normal within the unit. Customers rate this repair as Easy.

This is an authentic Briggs and Stratton replacement part manufactured for use with pressure washers. This gasket forms a seal between the pump head and inlet plate spacer. It is recommended to replace pressure washer gaskets when servicing the pump to ensure a proper seal when reassembling the pump. This head gasket is available as an individual replacement part.

This replacement trigger gun assembly is specially designed for use with a variety of pressure washers. It is the essential part of the unit that allows user to direct and control the spray. Please note the wand and the hose are both sold separately. This pistol assembly is made out of plastic with metal fittings. This handle is only for pressure washers up to 3000-psi using M22 hose connector.

It is a genuine item that is supplied directly from the original equipment manufacturer for use with Briggs and Stratton generators and pressure washers. The purpose of this component is to reduce the vibration of a working unit, unfortunately, over time it may begin to fail eventually requiring a replacement. Please make sure to refer to...Read more the appropriate diagrams of your model for the correct location and application of this part. Keep in mind this high-quality vibe mount with a washer is sold individually.

It is an authentic item that is supplied directly from the original equipment manufacturer for use with Briggs and Stratton and Troy-Bilt equipment. This is an identical replacement for a missing or a faulty push nut that was installed on a new unit, please make sure to refer to the appropriate diagrams of your model for the correct locat...Read moreion and application of this component. Keep in mind this high-quality push nut is made of durable plastic with metal and is sold in a pack of two.

This Chemical Hose Filter is a genuine replacement part for various models of pressure washers. It is made of durable blue plastic, is not part of a kit or assembly, is sold individually, and is used to prevent debris from being drawn into the pump. When this part is damaged or clogged, it can prevent the flow of water. This part can be...Read more removed and cleaned but will need to be replaced if it is worn or damaged. Customers rate this repair as Easy.