10278 Dynabrade Orbital or Palm Sander - Overview

This replacement lock washer is supplied directly from the original equipment manufacturer, it is specially produced for use with Dynabrade sanders. It helps to distribute the pressure between connected pieces ensuring a tight fit. This is a standard hardware which has multiple applications based on your model, for proper location and use...Read mores please refer to appropriate diagrams of your unit. This part is made of high-quality metal and it is sold individually.

This is a genuine manufacturer-supplied component which is specially made for use with Dynabrade sanders. It is an identical replacement for a missing or faulty screw that was installed on a new unit, please make sure to refer to the appropriate diagrams of your model for the correct location and application of this hardware. Keep in mind this high-quality screw is made of durable metal and is sold individually.

This replacement o-ring is an original Dynabrade part that is specially produced for use with sanders, drills and grinders. It is an authentic OEM item that has multiple uses depending on your equipment, please make sure to check appropriate diagrams for correct location and use of this o-ring. Note one durable rubber o-ring is included per order.

This is a manufacturer sourced replacement seal. It is specially produced for use with Dynabrade sanders. This is one of the seals for the tip valve/inlet bushing. Over time seals tend to shrink and crack allowing for air leaks. At that time it should be replaced to maintain top performance. It is made out of rubber material and it is sol...Read mored individually. Replacing this item you would need a wrench to replace this item.

This an authentic Dynabrade replacement part used in buffers and sanders. The spring is used to absorb shock from the valve when tool is in use. It goes between the air control ring and the tip valve. A wrench may be needed to properly install this part. This item is available as an individual replacement part.

This is a genuine Dynabrade replacement part designed for use with sanders/buffers. It fits inside the cylinder assembly. This set includes a plastic rotor and a set of five (5) blades. To replace it you will need a screwdriver and pliers.

This is an authentic Dynabrade replacement part that has been sourced from the original manufacturer to be used with orbital sanders. The isolator post is used to provide spacing between the housing and the backing pad to allow room for the bearing box. This item is sold as an individual replacement part.

This is a genuine Dynabrade replacement part manufactured for use with orbital sanders, and grinders. This special valve sits in the air inlet bushing, and is supported by a spring. The valve is sold individually, please see model diagram for additional parts that are available separately.

This part is genuine and sourced from original manufacturer. It is commonly found in Dynabrade sanders and grinders. A bearing will reduce friction between metal parts resulting in smoother and more effective motion. These are high wear parts that should need regular replacement. Sold individually.