1005 (1600400) Simplicity Tiller - Overview

The Oil Seal is used to seal the gear case where the axle extends from the case, around the axle shaft. It's rated as "Easy" to install, and will require a wrench set and seal puller. When installing, use something big enough to make contact with the entire seal, such as a PVC pipe, and tap gently into place. If broken, you will see oil ...Read moreleaking, and the part must be replaced. This gray, rubber part is sold individually. Refer to your make, model and diagrams to ensure this is the correct part for you.

It is an authentic item which is supplied directly from the original equipment manufacturer for use with Snapper and Simplicity lawn and garden equipment. The washer is generally utilized to provide a tight seal between connected pieces, please make sure to refer to the appropriate diagrams of your model for the correct location and appli...Read morecation of this hardware. Keep in mind this high-quality item is made of durable metal and is sold individually.

Lockwasher split 3/8

This is an authentic Simplicity replacement part. The idler pulley is designed by the manufacturer for use in lawn mowers and snow throwers. This part is made of metal, and is used to adjust tension on the V-belt. You will require a wrench when replacing this part. This item is sold individually.

Gear-2.968od 1.004id

Bearing-needle 1.000i

V-belt ha 034.10

Washer-thrust

                                                                                                &nbs...Read morep;                                                                                                                                                                                                                                                                      

This is a 30 amp dryer power cord that is 5 feet long and has 4 wires.

This is an authentic Patio Comfort replacement part, sourced from the original manufacturer for use with patio heaters. The hex head bolt is commonly used to secure the faceplate to the emitter grid assembly. This special bolt is available as an individual replacement part, please see illustrated diagram for associative parts.