100 (F013010000) Dremel Hammer Drill - Overview

This replacement power cord is supplied form original equipment manufacturer. It is specially made for Dremel rotary multi-tools. I plays a key role by delivering the electricity from the outlet to the tool. This cord is rubber insulated and it is sold individually. It does include a rubber grommet/sleeve. To complete this repair you wo...Read moreuld need a screwdriver. • Remove housing screws • Remove the housing • Disconnect wires from the old cord • Remove old cord • Secure the new power cord in place • Reattach wires • Reassemble and test the unit

This is an authentic Dremel replacement part that is designed for Dremel rotary multi-tools. In conjunction with armature its the central component of an electric motor that drives the unit. A field is usually damaged by overloading the power tool or it can be caused by a faulty armature. It is highly recommended to replace both carbon brushes when replacing a field. This durable metal item is sold individually.

This is a genuine Dremel replacement part, it is sold individually. The purpose of the Collet Nut is to secure the collet with the bit of your choice in the shafts assembly of the Dremel tools shown below. By pressing on the lock assembly on the tool and using the wrench provided with your tool you can secure or release the Collet Nut.

This is a Genuine Manufacturer Approved replacement part used on some Dremel Rotary Multi-Tools. This part provides the firm grip for holding a bit in a tool. This Collet is for using bits with 1/8" arbors. Due to prolonged, heavy use a collet may need to be replaced. Collet Nut is sold separately.

This is the lock pin assembly for various dremel and multi-tool models. The lock pin is a crucial component within power tools, responsible for securing the bits in place during use to prevent any movement. Over time, lock pins can wear down or become damaged, leading to improper engagement or hindering the rotation and functionality of t...Read morehe tool. Replacing a lock pin involves turning off the dremel or multi-tool and removing its motor brushes and housing screws that hold it together. Separate the housing into two halves, take out the motor, and locate the lock pin. Remove the lock pin and its spring, then install the new lock pin and spring. Reinstall the motor, the other half of the housing, along with its screws and bushings.

An authentic OEM sourced item that is supplied for use with Dremel power tools. This special ring helps to provide a seal for the armature, make sure to refer to the appropriate diagrams of your model for the correct location and application of this hardware. Keep in mind this high-quality component is made of durable rubber and is sold i...Read morendividually, over time the material may wear out and begin to crack eventually requiring a replacement.

It is a genuine item that is supplied by the original equipment manufacturer for use with Dremel tools. The switch allows a user to control the on-off function of the tool, over time components tend to wear out and they may begin to fail eventually requiring a replacement. Keep in mind this high-quality plastic body part is sold individua...Read morelly. Please make sure to refer to the appropriate diagrams of your model for the correct location and application of this item.

This item has been sourced from the original manufacturer to be used with rotating multi-tools from Dremel. The durable plastic cap is used to cover and support the carbon brushes. The cap allows you to access the brushes without having to disassemble the motor housing. This item is sold as a pair.

Original OEM replacement Armature Assembly used on some Dremel Corded Multi-Tools. This item includes an Armature, Fan, Armature Bearing, Commutator End Bearing, and the fan with pulley. Remember to be especially careful of the armature fan when you remove it, because if you break it, you will have to replace the entire armature. Due to c...Read moreonstant contact with Carbon Brushes armature will eventually wear out and would need to be replaced. It is highly recommended to replace both Carbon Brushes when replacing an armature.

Ideal for shaping, hollowing, grooving, slotting, inlaying and making tapered holes in soft metals, plastics and woods especially on curved surfaces.