100-3 Toro - Overview

The Ni Lock Nut (Nylock Nut) is a Silver, 5/16x18, individually sold metal nut. It can be adjusted and replaced using a wrench or socket and torque wrench to the manufacturer specfications, and is used to secure the sheer pin in place on the augur. These nuts are a one time use part due to their locking mechanism. You'll know the nut has...Read more broken because the augur will not spin, and this is when the part should be replaced. Customers found this to be an easy repair.

This is an authentic item that is supplied by the original equipment manufacturer for use with Toro lawn and garden equipment. It is a standard hardware which has multiple applications depending on the model of your unit, please make sure to refer to the appropriate diagrams of your model for the correct location and application of this i...Read moretem. Keep in mind this high-quality nut is made of durable metal and is sold individually.

This flat metal washer fits onto the speed guide-selector and is available individually. Please note that more than one washer may be needed when replacing parts. It will need to be replaced if it becomes lost or broken and may require a wrench during installation. This is an OEM Toro part sourced directly from the manufacturer and used in snowthrowers.

This replacement hardware is sourced from original equipment manufacturer for use with Toro snowthrowers. It is standard hardware which has multiple applications, please refer to appropriate diagrams for correct location and use of this locknut. This part is made from durable metal and it is sold individually.

This is a genuine Toro replacement part that has been sourced from the original manufacturer to be used with snowthrowers. The metal flat washer is used to disperse pressure put on a part assembly by a nut or bolt across a wider surface area. This item is used with several different models of snowthrowers. It is recommended to review your...Read more models part diagram to confirm the washers compatibility and usage. The flat washer is priced individually.

It is an authentic OEM part that is specially made for use with Toro and Lawn Boy snowthrowers. This is an identical replacement for a faulty or a missing hardware that was installed on a new unit. It is one of the screws utilized to secure the upper and the lower handles. This high-quality component is made of durable metal and is sold a...Read mores an individual item. Make sure to refer to the appropriate diagrams for your model to ensure the exact location and the correct application. A wrench will be needed to perform this repair.

A deck wheel that drags, wobbles, or has a flat spot may no longer protect the turf correctly. The smooth roller touches the ground when the mower deck passes over a raised area, helping prevent the blade from cutting deep patches. Check deck level and tire pressure first because poor adjustment can also cause scalping. Match the replacem...Read moreent using the complete mower model and serial number, and compare the bore, width, bracket spacing, and required hardware. Shut off the engine, remove the key, set the parking brake, and disconnect the spark plug before service. Support the deck securely, tighten the fastener properly, and make sure the wheel turns freely.

This authentic replacement part is supplied directly from the original equipment manufacturer for use with Toro lawn and garden equipment. It is an identical replacement for a missing or a faulty carriage bolt that was installed on a new unit, please make sure to refer to the appropriate diagrams of your model for the correct location and...Read more application of this hardware. Keep in mind this high-quality part is made of durable metal and is sold individually.

This individual rubber O-ring is a genuine OEM part for various outdoor equipment models and has an approximately 1-inch inner-diameter. O-rings are typically used to seal various gaps within hydraulic systems to prevent the escape of liquids or gases, and if you notice that the motor of your equipment is leaking or performing poorly, it ...Read moremay be a sign of an aging O-ring, because over time they lose their elasticity and crack. Be sure to check any diagram of your equipment for the exact placement of this O-ring.