09761-0 Briggs and Stratton Pressure Washer - Overview

Made of durable rubber and plastic components, this Fuel Valve and Bushing are designed for use in over 150 models of generators and pressure washers. This item is sold as a kit, including the valve and the rubber cap. Its primary purpose is to deliver fuel from the tank to the carburetor. This part is found on the underside of the fuel...Read more tank and should be replaced when it is worn or damaged. When malfunctioning, it may cause your engine to be starved of fuel and run rough or not at all. You will need a screwdriver and pliers to complete this repair. Customers rate this repair as Easy.

This flat washer is an OEM part that is silver in color, made of metal, and its job in your equipment is to spread load and pressure under a bolt. It can have multiple uses depending on your equipment, and can be used in a lot of different equipment, so be sure to consult your owners manual or check your part number to ensure this fits yo...Read moreur model. Over time the washer may become damaged; watch for cupping from over-tightening as a leading cause. This is a very easy part to repair and does not require any tools.

The OEM vibration mount is a black rubber part, which is used to prevent vibrations between the frame of the generator and the floor. It can be installed with a screw driver,and its installation is rated as "Easy" by customers. It is installed on the bottom of the frame, facing the ground. If broken due to general wear/fatigue, there will...Read more be a noticeable vibration and the part may be tilted to one side. If this happens, the part should be replaced. Refer to your model, make and diagram in order to ensure this is the correct part.

Chb 1/4c gr2 zp

This is a genuine OEM sourced component that is specially designed for use with Briggs and Stratton engines commonly installed on lawn and garden equipment. It is designed to keep the fuel in the tank. It provides an identical replacement for a missing or a faulty part that was installed on a new unit. Please make sure to check the approp...Read moreriate diagrams of your model for the correct location and application of this cap. Keep in mind this high-quality part is made of durable plastic and is sold individually.

This is an authentic Briggs & Stratton replacement part that has been sourced from the original manufacturer to be used with generator engines. The spark arrester screen connects to the muffler and is used to prevent embers from being discharged through the exhaust gasses. Over time the screen can become clogged from exhaust discharge and...Read more can inhibit the gasses from escaping. This item is available as an individual replacement part.

It is a genuine replacement part that is supplied by the original manufacturer for use with Generac generators. This is the special gasket that is utilized to provide an air-tight seal for the manifold, over time the material may wear out and begin to crack eventually requiring a replacement. Please make sure to refer to the appropriate d...Read moreiagrams of your model for the correct location and application of this hardware. Keep in mind this durable composite material gasket is sold individually.

The air cleaner element goes between the air cleaner cover and the canal cover. It is priced as an individual replacement part and helps to filter the air moving through the device. Filters will become dirty over time and will need to be replaced. This air cleaner is an OEM from Generac for use in generators and may require a screwdriver and a socket set in order to do the replacement.