0883 - Overview

The brush holder assembly in your generator keeps the brushes in place, allowing them to touch the rotor. It consists of a plastic brush holder and two carbon brushes with lead wires and attached springs. You can usually find the holder assembly inside the generator housing, near the rotor and stator assembly. If the holder assembly is br...Read moreoken, it can cause improper electrical contact between the brushes and the rotor, leading to a loss of electrical current transfer. Additionally, over time, the brushes will wear down from use, resulting in inconsistent contact with the rotor. Look for visible signs of damage like cracks, breaks, or deformations in the holder. A damaged holder can cause unstable voltage, power surges, or your generator failing to generate electricity altogether. To remove the existing brush holder assembly from your generator, refer to your user guide for detailed instructions. It may involve removing a cover or access panel to reach it. Use a nut driver or suitable tool to disconnect the assembly from the rear-bearing carrier and any connected wires. Remember to magnetize the brush assembly and conduct a generator test after installing the new one. Please keep in mind that this authentic OEM part is sold individually.

This starter rope is a genuine replacement part supplied by the manufacturer. It is compatible with over 150 machines including engines, generators, snowthrowers, and lawn mowers. This rope is attached to the starter pulley. When this rope is pulled, the starter pulley is rotated. This rotation starts the engine. The rope should be replaced if it is torn or cut. It is sold individually.

The battery charge rectifier goes inside the control box. It is an OEM from Briggs & Stratton for use in generators. This part is sold individually and is made of metal. A wrench and a screwdriver may be required to replace this part. It will need to be replaced if it breaks.

This item is available as an individual replacement part. The outlet is made out of metal and plastic. It may require a wrench during installation. This item will need to be replaced if it breaks. It is a replacement part directly sourced from the manufacturer for use in generators made by Briggs & Stratton and Snapper.

This is an original Craftsman replacement part manufactured for use with snow blades. The control cable is used to link the control lever to the cable bracket and is used to adjust the position of the snow blade. This control cable is available as an individual replacment part.

This is an authentic Milwaukee replacement part that has been sourced from the original manufacturer to be used with impact drivers, wrenches, and screwdrivers. The steel ball is used to reduce friction between the anvil and the impact assembly. The steel ball is priced as a single item.

This is an OEM part sourced directly from the manufacturer. The brush is designed for use in generators from Briggs & Stratton. This part is a complete carbon brush assembly, which is used to supply power to the rotor. You may require a screwdriver or Allen wrench when replacing this part. This item is sold individually.

This is an authentic replacement part sourced directly from the manufacturer. The insulator is commonly found in small engines from Briggs & Stratton. This part is made of a hard fiber composite, and is used to prevent electric current from grounding to components in the engine. This item is sold individually.

This is an authentic Briggs & Stratton replacement part. The bearing is commonly found in generators. This part is made of metal, and is used to allow the rotor assembly to spin freely within the stator. You may require a wrench when replacing this part. This item is sold individually.

This is a genuine part that is supplied by the original manufacturer for use with Briggs and Stratton and Toro engines. When pulled, the starter rope engages starter spring causing the engine turn fast enough for the ignition module to generate a spark to ignite the fuel in the cylinder. This part is made of nylon rope and is sold individ...Read moreually. To install the rope you will need a screw driver and socket wrench. Turn the starter spring to build tension and recoil the rope inside.