08647-1 Briggs and Stratton Generator - Overview

The Fuel Line Clamp is a metal, individually sold part which clamps onto the fuel line, securing it to a port and preventing leaks. Installation is rated as "Easy" by customers and will require pliers and a screwdriver. If broken due to wear/fatigue/damage, there may be a fuel leak and the part should be replaced. Refer to your make, model and diagrams to ensure this is the correct part.

This flat washer is an OEM part that is silver in color, made of metal, and its job in your equipment is to spread load and pressure under a bolt. It can have multiple uses depending on your equipment, and can be used in a lot of different equipment, so be sure to consult your owners manual or check your part number to ensure this fits yo...Read moreur model. Over time the washer may become damaged; watch for cupping from over-tightening as a leading cause. This is a very easy part to repair and does not require any tools.

This is a genuine replacement part that has been sourced from the original manufacturer to be used with snow thrower engines from Husqvarna and Toro. The metal screw is used to fasten the fuel tank to the tank mounting bracket. This item is available as an individual replacement part, please note a hex socket wrench may be needed to install this item.

Gear worm

This paper air cleaner element, also known as an air filter, is sourced from the original manufacturer for use in outdoor power equipment. It has an outer diameter of 4.25 inches and a height of 3 inches. The air filter is responsible for removing dirt and debris from the air before it enters the engine to keep the engine free from contam...Read moreinants. Over time, it is normal for the paper on the filter to tear or become clogged, thereby restricting airflow, increasing fuel consumption, and damaging the engine. Regularly inspecting and replacing the air filter is critical to maintaining the performance of your engine. To begin this repair, locate the air filter housing near the engine or carburetor and remove the cover. Carefully remove and discard the old filter, making note of its position. Clean the air filter housing and insert a new, clean filter in the correct position. Place the cover back onto the housing and ensure that it is tightly fitted to prevent air leaks.

This is an authentic Murray replacement part that has been sourced from the original manufacturer to be used with riding lawnmowers. The metal washer is used to provide spacing between the steering spindle and the front axle assembly. This item is sold individually, please note two washers may be needed.

This spark plug cover is supplied directly from the original equipment manufacturer. The rubber and metal component is often used in snowthrower engines, and is sold individually. The spark plug cover is fitted over the spark plug wire connection, providing protection. A screwdriver and pliers may be required for the removal and replacement.

This breather element is also called an air filter cartridge, cleaner element, or engine filter. It prevents debris from reaching the carburetor of your lawn equipment while allowing clean air to enter. This clean air-fuel mixture is essential for energy production. A broken or clogged breather element can lead to fuel flow issues, errati...Read morec operation, or starting difficulties. Neglecting to replace a damaged breather element can result in engine problems such as poor fuel combustion, reduced power, or engine stalling. To access the breather element, locate its housing on your machine using your instruction manual. Remove any necessary clips or screws with pliers or a screwdriver. You may also need to put oil on this breather element while installing it into your machine, according to instructions given by its manufacturer. This OEM-verified component is sold individually.