081502-9095-30 Briggs and Stratton Engine - Overview

This is an authentic manufacturer sourced replacement part designed for use with a variety of lawn and garden equipment. This carburetor intake gasket which provides an air tight seal for the carburetor. Over time gaskets tend to deteriorate and would need to be replaced. It is made out of compound material and it is sold individually. You would need a screwdriver to replace this item.

This air cleaner element is supplied from original manufacturer. It is specially designed for use with Briggs and Stratton engines used on lawn and garden equipment. It is used to filter out dust from entering the carburetor and the engine. This filter element is made out of foam material and it is sold individually. Please note, the air ...Read morecleaner cartridge is sold separately. Replacing this filter is a simple task that does not require any tools. • Unscrew the cover knob • Remove the cover • Remove old element • Secure the new element in place • Reassemble and test the unit

This authentic manufacturer-supplied washer is specially designed for use with Briggs and Stratton engines that are commonly installed on lawn and garden equipment. It is a special hardware that helps to provide a tight seal between connected components. This is an identical replacement for a missing or a damaged packing-needle valve that...Read more was installed on a new unit. One durable rubber part is included. Refer to the appropriate diagrams for your model to ensure the proper replacement procedure.

The needle valve spring goes next to the idle mixture valve and is made of metal. This is available as an individual replacement part. This authentic item is supplied directly from the original equipment manufacturer for use with engines, generators, tillers, blower-vacuums, and lawn mowers made by Briggs & Stratton and Toro. During repla...Read morecement, it may require a screwdriver and a wrench set to help install this part correctly. It will require replacing if it becomes bent or broken.

This is a genuine Briggs & Stratton replacement part. The screw is commonly found in yard equipment such as blowers and lawn mowers. This part is made of metal, and may be used in various locations in the machine, depending on model. Please be aware that there are different screws used in the machine. Refer to the parts diagram to be ...Read moresure of ordering the correct part. You will require a screwdriver when replacing this item. This part is sold individually.

This is an authentic replacement part manufactured for use with small engines. The metal cap is used to seal or cover the fill spout on the engine's fuel tank. This fuel tank cap is available as an individual replacement part, please see model diagram for associative parts.

This control rod clip is a genuine OEM replacement designed for small engine throttle linkages. It secures the control rod in place to help maintain consistent throttle response and stable engine speed during operation. Made from durable, corrosion-resistant metal, it’s an ideal replacement when worn or missing clips cause loose linkages or erratic engine behavior.

This is an authentic OEM part from Briggs and Stratton and Toro for use with garden equipment engines. The stop wire connects the ignition coil to the stop switch to ground the spark voltage to the engine block when you release the bail control bar. This part is sold individually. The tool that you will need to replace the stop wire is pliers.

A genuine item which is supplied by the original equipment manufacturer for use with Briggs and Stratton engines commonly installed on lawn and garden equipment. It is a high-quality gasket that helps to provide an air-tight seal for the fuel tank, please refer to the appropriate diagram of your model for the correct location and applicat...Read moreion of this item. Over time the material may wear out and begin to crack eventually requiring a replacement. Keep in mind this high-quality component is made of durable composite material and is sold individually.