06-44SC01 Toro Snow Blower - Overview

This Ni Nut-Lock, or Nylock Nut, is a Silver 1/4 x 20 metal nut. Sold individually, it can be adjusted using a wrench or socket and torque wrench to the manufacturer specfications, and is used to secure the sheer pin in place, on the impeller assembly. These nuts are a one-time use part due to their locking mechanism. You'll know the nut...Read more has broken when it appears to have damaged threads or rounded off edges. Customers found this to be an easy repair.

This is an authentic OEM self-tapping bolt used on Toro snow throwers/blowers. It is designed to secure the bushing/gear case assembly together. By using a wrench and a self tapping bolt, precisely fitted threads are created in the opening of the case. This allows for the two part to be secured tightly together. Please note this bolt is sold individually.

The Ni Lock Nut (Nylock Nut) is a Silver, 5/16x18, individually sold metal nut. It can be adjusted and replaced using a wrench or socket and torque wrench to the manufacturer specfications, and is used to secure the sheer pin in place on the augur. These nuts are a one time use part due to their locking mechanism. You'll know the nut has...Read more broken because the augur will not spin, and this is when the part should be replaced. Customers found this to be an easy repair.

This flat metal washer fits onto the speed guide-selector and is available individually. Please note that more than one washer may be needed when replacing parts. It will need to be replaced if it becomes lost or broken and may require a wrench during installation. This is an OEM Toro part sourced directly from the manufacturer and used in snowthrowers.

It is a genuine OEM sourced replacement part which is specially designed for use with Toro snowblowers. Please make sure to refer to the appropriate diagrams of your model for the correct location and application of this hardware. Keep in mind this high-quality screw is made of durable metal and is sold individually.

This rubber oil seal is supplied directly from the original equipment manufacturer for use commonly with snowblowers and a variety of other outdoor power equipment. It can be used to retain gear oil, seal the transmission, and prevent it from leaking out of the engine. The seal keeps the rotating parts adequately lubricated and protects t...Read morehem from friction damage. The seal also prevents dirt and debris from entering and damaging the equipment components. Over time the rubber material may wear down or tear, leading to oil leakage, increased friction, overheating, and damage to the equipment. To replace the seal, first drain the oil and use a seal puller or flat screwdriver to remove the old seal. Clean the area thoroughly to ensure a good fit for the new seal and add a thin layer of oil around the seal. Align the new seal on the mounting surface and use a seal driver or socket to press the seal down until it is secure. Remember to refill your oil before starting your equipment again.

This replacement hardware is sourced from original equipment manufacturer for use with Toro snowthrowers. It is standard hardware which has multiple applications, please refer to appropriate diagrams for correct location and use of this locknut. This part is made from durable metal and it is sold individually.

This item has been sourced from the original manufacturer and is intended to be used with snowthrowers from Toro. The metal woodruff key is used to link the motor drive shaft and the impeller pulley to allow the shaft to rotate the pulley. This woodruff key is priced as a single item.

This authentic replacement part is supplied directly from the original equipment manufacturer for use with Toro lawn and garden equipment. It is an identical replacement for a missing or a faulty carriage bolt that was installed on a new unit, please make sure to refer to the appropriate diagrams of your model for the correct location and...Read more application of this hardware. Keep in mind this high-quality part is made of durable metal and is sold individually.

This is an authentic replacement part manufactured for use with Toro snowthrowers. The special hex head screw is used with a variety of different snowthrower models and has multiple applications. This screw is available as an individual replacement part, please see model diagram for associative parts.