040307GEC-0 Briggs and Stratton Generator - Overview

A starter solenoid, also known as a starter relay, is an electrical component that is used within small engine systems to control the starter motor by engaging it when an ignition key is turned - acting as a bridge between the battery and starter motor. This starter solenoid is designed for use with various models of lawn mower and other ...Read moresmall engine equipment and is sold as an individual part with no securing hardware. Depending on your model and type of equipment, the location of the starter solenoid may be different, but it is typically located on or around the engine block, and close to the battery. If you notice issues with starting your equipment such as clicking sounds, intermittent starting or simply not starting at all, the solenoid may be burnt or damaged and need replacement immediately. You can test the solenoid for continuity on its terminals with a multimeter, but make sure to take safety precautions. To replace a starter solenoid, you need only disconnect the equipment from power, locate the solenoid, disconnect and remove any connections and securing bolts before you can replace it and test for full functionality.

The door hinge kit is sold as a set that contains all the necessary parts. They are made out of metal. These authentic items are supplied directly from the original equipment manufacturer for use with generators made by Briggs & Stratton. A screwdriver may be helpful when replacing these items. Over time these parts may break and will need to be replaced.

This is a genuine manufacturer-sourced replacement gasket which is specially designed for use with Briggs and Stratton equipment. It is utilized to provide an air-tight seal between connected pieces, please make sure to refer to the appropriate diagrams of your model for the correct location and application of this hardware. Over time the...Read more material may wear out and begin to fail eventually requiring a replacement, keep i mind this high-quality gasket is sold individually.

This is a genuine Briggs & Stratton replacement part. The gas fuel solenoid is designed by the manufacturer for use in generators. This part is made primarily of metal, and is used to control the flow of fuel to the engine. You may require a wrench when replacing this item. This part is sold individually.