0238-3 (SER 723-1001) Milwaukee Electric Drill - Overview

Genuine Milwaukee replacement part, this item is sold individually. This Chuck Key tightens the jaws of the 1/2 inch capacity Chucks on all the Drill models shown below. For convenience a Chuck Key Holder part number 48-66-4040 can be ordered. It is attached to the power cord then the Chuck Key is attached to it.

This is a genuine Milwaukee replacement part, it is sold individually. The purpose of the 06-75-3150 Screw is to secure the chuck to the spindle of the models listed below. This is a left hand threaded screw, to remove it turn it clockwise. We do have an article and video on

This authentic replacement part is designed for use with Milwaukee drills/drivers. Ball bearings are used to reduce friction between rotating parts. The balls or rollers take the load and spin, distributing the weight evenly while the minimal contact area of the ball reduces friction. Bearings experience constant wear from pressure, heat,...Read more vibration and friction. Because of this, many bearings need to be periodically replaced. This part is made out of metal and it is sold individually.

This cord protector is a genuine Milwaukee replacement part and is sold individually. Cord Protectors are designed to slide onto your cord and fit securely at the end, where it's firm rubber will protect the base of the cord from getting bent and pinched, which can expose the wires and become a safety hazard.

Included in part number 14-13-0465

It is an authentic manufacturer approved replacement item that is specially produced for Milwaukee drills. This metal bearing helps to secure intermediate pinion gear while allowing it to spin freely with minimal friction. Over time this part may wear out and restrict movement, if this happens it can easily be replaced. Please note this high quality item is sold individually.

This is a genuine Milwaukee part, it is sold individually. The chuck is the top portion of the drill that holds the different drill bits. It is compatible with a variety of drills listed below. If your drill's bit retention is suffering, the rotation feels stiff, or the chuck has seized up entirely, a new chuck should fix the problem. Thi...Read mores chuck is made of metal. To install this chuck, thread the new chuck assembly onto the spindle. Secure the chuck assembly as tightly as possible( by hand). Open the chuck to accept the retaining screw. Install the retaining screw and secure the screw with a Phillips screwdriver. The screw is reverse-threaded ( requiring counterclockwise rotation to secure.

This is an authentic OEM sourced part which is specially designed for use with Milwaukee electric drills and drivers. The bearings are generally utilized to reduce the friction between rotating parts. The balls or rollers take the load and spin, distributing the weight evenly while the minimal contact area of the ball reduces friction. Un...Read morefortunately, over time components will wear out and may begin to fail eventually requiring a replacement. Keep in mind this high-quality ball bearing is made of durable metal and is sold individually. Please make sure to refer to the appopriate diagrams of your model for the correct location and application of this hardware.

This is a genuine replacement carbon brush which is supplied by the original equipment manufacturer for use with Milwaukee power tools. Carbon brushes play an important role by conducting the current in an electric motor that drives the unit, over time carbon brushes will gradually wear out eventually requiring replacement. It is recommen...Read moreded to replace both brushes at the same time, please note this high-quality part is sold individually.

This Chuck Key Holder securely attaches chuck key 48-66-3280, 48-66-2110, 48-66-3480, 48-66-3080 or 48-66-3240 to the cordset of your drill which has chuck 48-66-0240, 48-66-0795, 48-66-0797, 48-66-0805, 48-66-1360, 48-66-5185, 48-66-1381 or 48-66-2100 on it.