0195210 Presto Pressure Cooker - Overview

Genuine Presto replacement part, it is sold individually. This is a safety feature for the Presto products listed below. Once the pressure is at a certain point the center of this part will pop up. This will not allow you to remove the lid until either the pressure is released by the pressure regulator or the cooker has been taken from the heat source. This part is also known as a pressure cooker interlock.

This is a genuine OEM sourced part used on many pressure canning devices. The pressure canner pressure regulator is constructed of high-quality metal, and includes two 5 pound rings and the regulator body. This item manages the pressure amount in the canner. No tools should be required for making the installation. The pressure canner pressure regulator is sold individually.

Genuine Presto replacement part, this item is sold individually. The 85707 Cooking/Canning Rack is placed in the bottom of the Pressure Canners shown below. It is above the bottom of the the pot approximately 1/4-1/2 inch. If it was laying flat on the bottom of the canning pot, the heat from the pot would cause the canning jars to break.

This is an Authentic Manufacturer Sourced replacement part used on certain Presto Pressure Canners. The steam gauge registers pressure readings during canning and cooking. Includes a Metal Gauge, Rubber Washer, Metal Washer, and a Metal Nut.

Genuine Presto replacement part, this item is sold individually. This part acts as a seal for the 85407 Air Vent Cover Lock on the Presto Pressure Cookers & Pressure Canners listed below. It is placed above the ring on the inside of the lid for the cooker.

This part is an OEM from the Presto manufacturer. The body handle is compatible with several pressure canning devices. This metal component is secured onto the body, supporting the handle cover. The handle helps the user to carry or move the device. The body handle is sold individually. A screwdriver is needed for the proper repair.

This is a genuine Presto replacement part designed for use with pressure canners and cookers. This vent pipe is a safety feature, once the pressure is at a certain point the center of this part will pop up. This will not allow you to remove the lid until either the pressure is released by the pressure regulator or the cooker has been taken from the heat source. It is made out of metal and it is sold individually.