My Orders
Magic Chef Cooktop Knobs
GET YOUR OFFICIAL Magic Chef PARTS TO ENSURE VICTORY
Shop By Part Type
View MorePopular Magic Chef Cooktop Knobs
This infinite switch knob is two inches in diameter and is black in color. This knob has a red indicator line as well as light gray lettering denoting the temperature level and the off, low, and high positions. The switch knob allows you to control the heat of the surface burner on your range. To replace the knob, you simply pull the old knob off with your hands and snap the new one into place. The knob may become old and worn over time and will need to be replaced.
This infinite switch knob is two inches in diameter and is black in color. This knob has a red indicator line as well as light gray lettering denoting the temperature level and the off, low, and high positions. The switch knob allows you to control the heat of the surface burner on your range. To replace the knob, you simply pull the old knob off with your hands and snap the new one into place. The knob may become old and worn over time and will need to be replaced.
This small black knob is used to turn on the igniter.
This small black knob is used to turn on the igniter.
Installation Instructions
DAVID from SEARCY, AR
Inside Of Knob Busted Out, Would Not Turn Ignitor.
Actually too simply to list as diy job. Merely remove old knob and push new one onto spindle.
Sold Individually. This knob accepts a D-shaped shaft.
Sold Individually. This knob accepts a D-shaped shaft.
Installation Instructions
Cindy from Uniontown, AR
oven woulfd not shut off when temp reached
very to install thermostat and probe...took about 30 mins. with the old therm exposed i just disconnected the wires one at a time reconnecting onto new therm one at a time...works great now.
Sold individually.
Sold individually.
Sold individually. This knob accepts a D-shaped shaft.
Sold individually. This knob accepts a D-shaped shaft.
Installation Instructions
Anna from MONROVIA, CA
My cooktop knob melted
I had used a pan too large for the middle burner - result: melted knob. Just pulled the old one off (up and straight) and then pushed the new one down firmly. Make sure the indicator line is pointing at you, so the flat side of the spindle matched the flat side of the hole on the knob. Easy peasy.
MAKE THIS REPAIR A GUARANTEED WIN
OVER 2 MILLION PARTS TO ENSURE VICTORY
These black knobs accept a D-shaped shaft.
These black knobs accept a D-shaped shaft.
Installation Instructions
jacqueline from falls church, VT
Knobs were worn, panel trim was scratched
This 'repair' was very straight forward. Just pull the knobs off and install new ones. The panel trim was just as easy.
The parts were received as described.
I have order from here before and will continue to order from them.
Thanks
The parts were received as described.
I have order from here before and will continue to order from them.
Thanks
Sold individually. This knob accepts a D-shaped shaft.
Sold individually. This knob accepts a D-shaped shaft.
Installation Instructions
Thomas from ROGERSVILLE, TN
One control knob got partially melted by a hot pan touching it.
I never did receive the part. It was a knob. Part numberPS11744700. Must've got lost in the mail. Thanks. Thomas Horne, 266 Eedmont Ct., Rogersville,Tn 37857?............P.S. The cost of it cleared my bank.
This igniter knob is less than two inches in diameter and a little over an inch high. It is a black knob with white lettering along its perimeter.
This igniter knob is less than two inches in diameter and a little over an inch high. It is a black knob with white lettering along its perimeter.
Installation Instructions
Randall from Rochester, NY
igniter would no longer work, it would stick
pull knob off streight out. remove two phillips head screws, disconnect wire to disassemble. To reassemble reattatch wire to replacement igniter, screw in two phillips head screws and push on the knob.
This burner knob is a little over two inches in diameter. This knob has gray lettering denoting the off, low, light, and high positions. It also has a red indicator line and a line of decorative red flames denoting the temperature level. This knob will accept a 'D' shaped shaft.
This burner knob is a little over two inches in diameter. This knob has gray lettering denoting the off, low, light, and high positions. It also has a red indicator line and a line of decorative red flames denoting the temperature level. This knob will accept a 'D' shaped shaft.
Installation Instructions
John from Pittsburgh, PA
Burner knobs broken and discolored
This was a simple operation in that it was necessary to only remove two screws on the faceplate of the cook top. But the real story is the incredible service from "PartSelect.com". The service was fast and the feedback on tracking and shipment was accurate and right on target as to delivery. I purchased several items over the December hol
... Read more
idays, and this company stands in the top 1 % in terms of ethical dealing and customer support. I have more parts to buy and you can be sure that I’ll buy them from PartSelect.
John Snyder
John Snyder
Read less
This top burner knob is just over two inches in diameter. It is black in color and is made of plastic. This knob has white lettering denoting the off, low, light, and high positions. It also has a red indicator line and a line of decorative red flames of various sized denoting the temperature level. This knob will accept a 'D' shaped shaft.
This top burner knob is just over two inches in diameter. It is black in color and is made of plastic. This knob has white lettering denoting the off, low, light, and high positions. It also has a red indicator line and a line of decorative red flames of various sized denoting the temperature level. This knob will accept a 'D' shaped shaft.