MTD Edger Control Cables

MTD Edger Roller: Cable This is an authentic part that has been sourced from the original equipment manufacturer for be used with lawn and garden equipment. The part helps to support and guide the cable. It is an identical replacement for a missing or a damaged component that was installed on a new unit. Keep in mind this high-quality cable guide is sold as an individual item.

MTD Edger Throttle Cable This throttle cable is responsible for controlling the engine speed in edgers. It is a manufacturer-approved cable designed with specific end fittings that connect to the throttle control lever on one end and the carburetor on the other. When the throttle control lever is adjusted, the cable transmits the motion to the carburetor, which allows the user to regulate the engine speed. Over time, the throttle cable can wear out, fray, or become disconnected, leading to loss of throttle control, lower power output, and engine stalling. To replace the throttle cable, first ensure the engine is off and cool, for your safety. Locate the end fittings on the cable and disconnect them carefully. Remove the fasteners that secure the cable, and then route the new cable along the same path as the old one. Finally, reconnect the end fittings, and adjust the cable tension as necessary.

MTD Edger Throttle Control Wire 35" Lg. This is an original part MTD, Yard-Man, Yard Machines, Troy-Bilt and Ryobi part for use with Lawn Tractors. The throttle cable stops the engine when you shift the lever to the Stop position. The most common reason for replacing the throttle control is when the engine doesn't throttle up when the throttle lever is increased. This part is sold individually. The tools that you will need to replace the throttle cable are a 3/8 inch socket, -+ inch socket or nut driver, 5/16 inch socket or nut driver.

MTD Edger Wheel Adjust Cable This wheel adjustment cable is used for both lawn edgers and trimmers and measures 32.75-inches in length. Featuring a metal cable insulated with rubber, this cable is used to raise or lower the blade within your equipment to control the cutting depth and is connected to a lever near the handle. Depending on your model, the installation instructions may vary, so check your user manual or any relevant diagrams for assistance.

MTD Edger Cable Guide

MTD Edger Throttle Assembly

MTD Edger Tensioner Cable Assembly

MTD Edger Tie-cable

MTD Edger Cable-depth Contro