Little Wonder Edger Engines

Little Wonder Edger Piston Ring This piston ring is an authentic manufacturer approved replacement part. Is is commonly used on Echo gas trimmers/edgers. The purpose of a piston ring is to create an air tight seal inside the cylinder. A worn or broken piston ring will allow combustion gases to escape the seal and enter the crankcase. This would cause low compression and a loss of power. Replacing an o-ring should resolve this issue. This part is made out of metal and is sold individually. To complete this repair you will need a set of wrenches, pliers and a screwdriver. • Remove the air cleaner • Drain the fuel • Remove the air cleaner case • Remove the carburetor • Remove the intake insulator • Remove the spark plug • Remove the engine cover • Remove the insulator gasket • Remove the starter assembly • Remove the fuel tank • Remove the air duct • Separate the engine • Bind the engine • Remove the clutch • Remove the flywheel • Remove the starter pulley • Unbind the engine • Remove the muffler • Separate the cylinder from the crankcase • Remove the piston ring • Install the piston ring • Reassemble and test the equipment

Little Wonder Edger 3 H.p. Kawasaki Engine

Little Wonder Edger Honda Engine 13 Hp W/ Tank

Little Wonder Edger Crankshaft Comp.

Little Wonder Edger Cylinder

Little Wonder Edger Piston

Little Wonder Edger Engine Spacers

Little Wonder Edger Engine, Kawasaki, 13 Hp

Little Wonder Edger Engine, Briggs & Stratton, 10.5 Hp