Kobalt Compressor Parts

This is a genuine Campbell Hausfeld replacement drain valve, sold individually. When using an air compressor, moisture naturally condenses inside the tank. If this water is left sitting for too long, it can lead to internal rust and damage. The drain valve allows you to release this built-up moisture easily. It's especially important to drain your tank after each use—particularly if you tend to leave air in the tank for extended periods. Regular draining helps extend the life of your compressor and maintain its performance. Be sure to open the valve regularly to prevent water buildup and potential tank corrosion.

This is a genuine OEM sourced replacement part used on Campbell Hausfeld air compressors. Its purpose is to filter out dust and debris from contaminating the engine. This filter is made out of paper and metal. This item is sold individually. To replace this you would need a wrench to remove the air cleaner cover.

This is a genuine OEM approved replacement drive belt. It is supplied by original equipment manufacturer for use with Campbell Hausfeld air compressors. This is the belt that connects the pump and the electric motor. Over time these rubber belts tend to wear out and stretch eventually requiring replacement to maintain peak performance. Always make sure to clean the pulleys before installing the new belt, this will help to ensure longevity of the new belt. Includes one (1) belt per order. Replacing this belt is a very simple task that should only require a screwdriver. • Make sure to unplug the compressor and drain the tank • Remove the cover screws • Separate the cover from the unit • Remove the old belt • Clean the pulleys • Install the new belt • Secure the cover with the screws

It is an authentic part that is supplied by the original manufacturer for use with Campbell Hausfeld air compressors. This is an identical replacement for a damaged or a faulty electric motor that was installed on a new unit. Refer to the appropriate diagrams for your model to ensure the correct repair procedure. Keep in mind this high-quality electric motor is sold individually. Note, the hardware to secure it is sold separately. A wrench set will be needed to replace this part.

This is an original Campbell Hausfeld replacement part manufactured for use with air compressors. This v-belt is driven by the electric motor, and drives the pulley on the pump. Belts can eventually wear out and break causing the pump to stop building pressure. The belt is sold individually.

This is a genuine replacement part that has been OEM sourced to ensure a high-level of quality. The 230v 1 phase electric motor is intended to be used with air compressors from Campbell Hausfeld. The thermally protected motor is used to drive the compressor\\\'s pump assembly. The motor is priced as a single item.

A genuine item that is supplied directly from the original equipment manufacturer for use with Campbell Hausfeld air compressors. It is an identical replacement for the electric motor which was originally installed on the new unit, over time components may wear out and begin to fail eventually requiring a replacement. Please note this high-quality motor is sold individually.