Karcher Parts

Genuine Karcher replacement part, this item is sold individually. The purpose of this part, is to attach the Female Hose Connector to the Piston Guide. This part is made of plastic and has plastic threads that do wear out. It may be wise to have an extra one or two on hand.

Genuine Karcher replacement part, it is sold individually. This part along with the piston controls the flow of water through the pump assembly. This part has a tendency to wear out. It may be wise to keep a few extra on hand.

Genuine Karcher replacement part, this item is sold individually. This part acts as a seal to keep the oil in the reservoir and the water in the pump form contaminating each other. It is installed on the piston.

This OEM Grooved Ring is a 12 x 20 x 4/6 rubber ring which can be installed with a screwdriver and wrench set. Installation is rated as "Medium" difficulty. It attaches in the cylinder head and is used to keep the oil in the pump from mixing with the water. If broken it will leak and must be replaced.

Genuine Karcher replacement part, this item is sold individually. This O-Ring/ Seal is part of the water inlet system of the Pressure Washes shown below. Over time this type of part will deteriorate and fail. At this time you will notice a water leak and need to replace this part.

Genuine Karcher replacement part, this item is sold individually. The purpose of the 9.181-005.0 Filter Seal Hose Connector is to act as a seal to keep water from leaking out of the hose connection. It also will keep debris from entering the pump and causing it to fail.

This genuine Karcher replacement part is sourced directly from the original manufacturer and is designed for use with compatible pressure washers. The plastic cap attaches securely to the pump housing and serves as a cover for the oil fill spout, helping to protect the internal components from dirt and debris. Durable and easy to install, this cap is available as an individual replacement part and is ideal for maintaining the performance and longevity of your pressure washer.

This part is a Retrofit Valve that will work on the older models as well as the newer models. Older units have shorter valves than the new pumps but you can change the length of the stem to adjust for the older units.

This is a high-quality pressure spring that is made for use with Karcher pressure washers. It is an authentic item that is supplied from the original manufacturer. The spring applies tension on the piston that helps to create pressure inside the cylinder. Over time it may wear out, get damaged or lost eventually requiring a replacement to maintain your pump. Refer to the owners manual and the diagrams of your model for the correct installation. Note, this pressure spring is made of durable metal and is sold as an individual item. To perform this repair you will need a screwdriver and a wrench set. Remove the cover and the cylinder head to gain access to the pressure spring.

This is a Genuine Manufacturer Sourced replacement part used on Karcher Pressure Washers. This item is made out of Metal and it is Sold Individually. This Female Garden Hose Connector in conjunction with Male Adapter is used to attach Garden Hose to Pressure Washers Pump. Requires a Wrench to secure.