Ingersoll Rand Parts

This is a genuine OEM replacement part used with many impact wrenches. The reverse valve knob is fastened to the bushing in the motor housing assembly, assisting with the direction of the drill bit. This metal item is sold individually, and a hex key is often used for making the replacement.

An air hammer that responds slowly or does not start when its trigger is pressed may have a worn throttle plunger assembly. This small moving assembly works inside the throttle valve to help control compressed air entering the tool. Check the hose, air pressure, trigger, seals, and nearby valve pieces before choosing a replacement. Confirm fit with the complete tool model because similar plungers may differ. Shut off and disconnect the air supply, then release stored pressure before service. Keep small springs and seals in order, use only the lubricant named in the service manual, and test the trigger carefully after reassembly.

Restore a firm blade connection with this replacement collet assembly for an air-powered reciprocating saw. The assembly grips the blade and keeps it in place while the saw is cutting. It may need to be replaced when the blade will not stay tight or the original collet shows signs of wear or damage. Check the blade and nearby holding parts before choosing the repair. Always remove the air supply before taking the tool apart. For the best fit, compare this assembly with the part being replaced.

An air tool that responds poorly when its trigger is pressed or released may have wear inside the throttle assembly. This replacement steel spring works with the throttle ball to support proper airflow control. Correct spring tension helps the throttle pieces move as designed, but the ball, seat, plunger, seals, and trigger should also be inspected. Clean the area and replace any damaged pieces found during service. Shut off the compressor supply, disconnect the air line, and press the trigger to release trapped pressure. Work over a clean surface so small pieces are not lost, and use the exploded parts diagram to confirm their order and direction.

A pneumatic hammer that runs poorly or responds unevenly may have damage inside its throttle system. This replacement ball works with the spring and seat to help control the compressed air entering the tool. Check the ball for wear, rust, dirt, or surface damage. Also inspect the seat, plunger, seals, and spring because replacing only one piece may not correct the problem. Shut off the air supply and disconnect the hose before service. Press the trigger to release trapped pressure and remove the working bit. Take apart the handle over a clean tray, keep the small pieces in order, and use the tool diagram during reassembly.

This is an authentic component which is sourced directly from the original equipment manufacturer for use with Ingersoll Rand air grinders. This part is made of layered fabric and laminate and is used to spin the rotor. This part is designed to slowly wear down over time, to avoid damage to the cylinder. It is advisable to replace all the rotors at the same time for even wear. Keep in mind this high-quality vane is sold in a pack of four. Please make sure to check the appropriate diagrams of your model for the correct location and application of these parts.

The socket retainer fits between the ring and the pushing. This is made of metal and is available as an individual replacement part. It is a genuine item that is supplied by the original equipment manufacturer for use with Ingersoll Rand impact wrenches. A screwdriver may be helpful when replacing this part. It will need to be replaced if it becomes broken.

Secure pad mounting is essential for safe, smooth sanding. Damage to the retaining nut can allow the backing pad to loosen, vibrate, or separate from the spindle. Check the nut threads and pad center before ordering a replacement. Match the part to the full sander model and parts diagram. Shut off and disconnect the compressed-air supply, wait for the tool to stop fully, and wear eye protection. Never use a cracked nut or force a part with the wrong thread onto the spindle.