Impact Driver Hardware

This external retaining ring, also known as a snap ring or circlip, is supplied by the original manufacturer for use in impact drivers. It helps to secure the collar in the front housing assembly. It should be replaced if it is lost, damaged, or no longer able to remain securely attached. To replace the retaining ring, disassemble the front housing assembly and pull out the ring. Position the new ring in its place and reassemble the housing. Each retaining ring is sold individually.

This is a genuine OEM part sourced from the manufacturer. Sold individually. Washer provides a bearing surface for fastener load distribution or acts as a spacer. Is used in a number of impact drivers, listed below.

Genuine Manufacturer Sourced replacement part used on a variety of Makita Power Tools. This is a Metal Pan-Head Screw and it is sold individually. This screws is commonly used to hold two pieces of Housing Set together.

Genuine OEM replacement part, this item is sold individually. This screw is used in various places in all of the tools listed below The most common use for this screw is to secure plastic housings together. It has a Torx T-20 head.

This is a genuine Milwaukee replacement part, it is sold individually. The Milwaukee Belt Hook is attached to the bottom of the handle assembly on the tool model numbers shown below. Its purpose is to hook the tool to your belt when not using the tool. The Belt Kit includes the screw to attach it to the housing of the tool.

This is a genuine OEM sourced replacement part which is specially designed for use with Milwaukee power tools. Washers are generally utilized to provide a tight seal between connected parts, over time it may wear out and begin to fail eventually requiring a replacement. Keep in mind this high-quality hardware is made of durable metal and is sold individually. Please make sure to refer to the appropriate diagrams of your model for the correct location and application of this item.

This replacement clip is an authentic OEM component which is made for Makita impact wrenches. The part is secured in the anvil and it helps to apply tension on the socket to secure it. Over time it may wear out and lose tension eventually requiring a replacement. If a socket does not stay put on the anvil, a faulty or a damaged clip may be the cause. Make sure to refer to the appropriate diagrams of your model for the exact location and the correct installation of this clip. One durable metal item is included. You will need pliers to remove the old one and secure the new one in the anvil.

This is an authentic replacement part that is sourced from the original manufacturer for use with hedge trimmers. The special screw is commonly used to secure the front guard assembly. This screw is sold as an individual replacement part, please note four screws may be required.

This is a genuine Dewalt replacement part designed for use with a variety of power tools. It is a standard hardware which has multiple applications based on your tools. This is a metal torx T-10 screw which is sold individually.

This authentic Makita replacement part is designed for use with impact wrenches. This pin fits in the anvil and it helps to hold sockets in place. This part is made out of metal and it is sold individually. To complete this repair you would need a screwdriver and pliers.