Hammer Power Cords

Length: 8' Gauge: 18 Wires: 2 Type: Bare Wire This cord is a genuine DeWalt replacement part. This cord is compatible with the list of models below. This part is made for double insulated tools It is a two wire cord with two prongs and does not need a ground wire. The cord is sold individually. Installation of this part requires the new cord wires to go correctly into wire terminals also routing the cord and wires in the right path can help avoid pinching when the tool case (Plate) is put back into place.

Length 8 Foot Length: 6' Gauge: 18 Wires: 2 Type: Bare Wire This power supply cord is a genuine OEM sourced replacement part. It is specially made to supply power from a standard outlet to Makita power tools. A cracked or damaged cord should be replaced before continuing to use the tool. This rubber insulated cord is sold individually. It comes with a rubber sleeve grommet that is not sold separately. Replacing this power supply cord you will need a screwdriver. • Remove the housing screws • Remove the the housing • Disconnect the old cord wires • Remove the old power cord • Secure the new cord in place • Connect the wires • Reassemble and test the new cord

This genuine cord protector, also known as a strain relief boot, is designed to safeguard the power cord where it enters your tool housing. Made from flexible, durable material, it helps prevent the cord from bending, twisting, or fraying during regular use, supporting safe and reliable performance. Small but essential, this component is an effective replacement if the original protector is worn or damaged, helping extend the life of your tool and maintain proper cord alignment.

This part is genuine and OEM. It is manufactured for DeWALT handheld power tools. A cord protector guards cord/wire connection from wear and tear caused by pulling, bending, and other strain. It is recommended to replace a damaged cord while replacing cord protector. One (1) rubber cord protector is included. Replacement cords are sold separately. This is an easy and quick fix. • Unplug tool • Remove outer casing • Detach cord from tool • Slide new cord protector onto cord • Reattach wires and casing • Test power tool

This replacement power cord is sourced directly from original equipment manufacturer. It is not an aftermarket imitation. It is specially designed to deliver power on Makita power tools. One rubber insulated power cord is included per order. Please note, the cord protector is sold separately. You will need a screwdriver to replace this item.

This cord is a genuine DeWalt replacement part and is sold individually. It is constructed with tough, thick outer rubber insulation for a long service life. Power Cord Specifications: • 3 Prongs • 3 Wires • 16 Gauge • 15 Feet Long

This is an authentic replacement part manufactured for use with Makita demolition hammers. The power cord is used to supply the demo hammer with electricity. This cord is a two wire cord and is available as an individual replacement part, please note the cord protector is available separately.

This cord is a genuine DeWalt replacement part and is sold individually. It is constructed with tough, thick outer rubber insulation for a long service life. Power Cord Specifications: • 3 Prongs • 3 Wires • 14 Gauge • 8 Feet Long

This is an authentic DeWalt replacement part that has been sourced from the original manufacturer to be used with breaker hammers. The three wire cord is encased in a durable sleeve and is used to relay electricity from the outlet to the switch assembly. This item is available as an individual replacement part.

This rubber piece is a genuine OEM part manufactured for DeWALT and Black & Decker. It is sold individually. A cord protector attaches at the point of connection between cord and power tool. It protects cord and wires from damage caused by stress, strain, and motion. This repair is fairly simple and requires just a screwdriver. A damaged cord must be replaced as well. Replacement cords are sold separately. • Unplug power tool • Remove the casing • Detach wires from tool • Slide cord protector onto cord • Reattach wires and casing • Test power tool