Grinder Hardware

This is a Genuine Manufacturer Sourced replacement part used on Dewalt Angle Grinders. The purpose of this Clamp Washer is to provide support for the Grinding Wheel to the Spindle Shaft. This Clamp Washer is made out of Metal and it is Sold Individually. You would need Hex Wrench to replace this part.

Secure wheel mounting is essential for safe angle-grinder operation. A stripped, cracked, or bent retaining nut can allow the accessory to wobble or loosen at high speed. Check that the wheel type, bore, inner flange, and spindle threads are correct before ordering a replacement. Match the nut to the full tool model and parts diagram. Disconnect power, wear eye protection and gloves, and use the approved wrench. Never install a damaged wheel or force a nut with the wrong thread onto the spindle.

The spindle lock pin fits next to the o-ring and the spring. This item is priced individually. It is an authentic OEM sourced item which is specially produced for use with DeWALT angle grinders. A screwdriver may be necessary during the installation of this part. The pin is made out of metal and will need to be replaced if it bends or breaks.

This replacement screw is a high quality hardware commonly utilized on Bostitch, Black and Decker, Porter Cable and Dewalt equipment. This is a authentic OEM item which has multiple applications depending on the unit, for correct location and use of this screw make sure to check appropriate diagrams. Please note this torx screw is sold individually.

Genuine Makita replacement part, this item is sold individually. The purpose of this Clamp Nut is to secure the Grinding wheel to the spindle of the Grinders shown below. To tighten the nut to the spindle, you will need to depress the spindle lock assembly on top of the gear case. Then use the part number 782422-3 Spanner Wrench to loosen and then tighten the nut back on.

Genuine Makita replacement part, this part is sold individually. This screw is used to secure various internal and external parts in the tool models shown below.It is a metric screw sized M4 X 16 (W, SW).

This screw is commonly used on a variety of power tools. It is a genuine OEM sourced replacement part. Please make sure to check appropriate diagrams for correct location and use of this screw. Includes one pan head screw per order. You will need a screwdriver to install or remove it.

This replacement screw is an authentic manufacturer sourced item. It is commonly used with a variety of power tools. This screw is a standard hardware which has multiple uses based on equipment. To ensure correct location and application of this item please make sure to check appropriate diagrams. It is made out of metal and it is sold individually. Requires a torx or a flat-head screwdriver to tighten/loosen this screw.

Genuine Manufacturer Approved replacement part designed to work with certain Makita Angle Grinders. This part is made out of Metal and it is Sold Individually. This Shoulder Pin is part of the Lock Button Assembly.

it is an authentic high quality Makita replacement part that is specially manufactured for use with sanders and grinders. This is the insulation washer for the armature, please make sure to check appropriate diagrams for correct location and use of this item. One durable plastic washer is included per order.