Generator Bearings

This manufacturer-supplied replacement part is designed for use with Kohler engines commonly installed on lawn and garden equipment. The bushing helps to secure the throttle linkage. It provides an identical replacement for a missing or a faulty hardware that was installed on a new unit. Please refer to the appropriate diagrams of your model for the exact location and the correct installation of this part. Keep in mind this high-quality bushing is made of durable plastic and is sold individually. You will need a wrench set to remove the housing in order to gain access to the bushing.

This is an authentic part which is supplied by the original manufacturer for use with Generac portable generators. It is utilized to secure and provide a tight fit for the fuel tank valve. This is a high-quality replacement for a damaged or a missing hardware that was installed on a new unit. To ensure the correct location and application of this part, refer to the appropriate diagrams of your model. It is made of durable rubber and is sold individually. You may need pliers to remove and secure the bushing.

Made of durable rubber and plastic components, this Fuel Valve and Bushing are designed for use in over 150 models of generators and pressure washers. This item is sold as a kit, including the valve and the rubber cap. Its primary purpose is to deliver fuel from the tank to the carburetor. This part is found on the underside of the fuel tank and should be replaced when it is worn or damaged. When malfunctioning, it may cause your engine to be starved of fuel and run rough or not at all. You will need a screwdriver and pliers to complete this repair. Customers rate this repair as Easy.

Rebuild Kit

This is a ball bearing that is used to reduce friction between the crankshaft and crankcase cover within various small engines. This bearing is sold as a singular part from its original equipment manufacturer and is made of high-quality metal. Featuring a 2.05-inch (52mm) outer diameter and a .98-inch (25mm) inner-diameter, this bearing prevents excessive noise, rattling, wobbling and vibrations from interfering with the crankshaft and crankcase as a whole. If you notice any of those things, you need to inspect this bearing for damage or wear immediately to prevent further damage to any other internal components. Replacing this bearing will require you to use a screwdriver and wrench to gain access to the internal portion of the engine for equipment. First, disconnect the spark plug and make sure to adhere to any equipment manufacturer assembly instructions, such as removing the engine cover, ignition coil and carburetor. Once you have access to the bearing location, remove it and ensure the entire area is cleaned and lubricated adequately before installing the new bearing and aligning the crankshaft. After that is complete, you can carefully reassemble the motor.

This is an authentic manufacturer-sourced part which is specially made for Ridgid drain cleaning machines. It is an identical replacement for a missing or a faulty bushing that helps to secure the drum support, please make sure to refer to the appropriate diagram of your model for the correct location and application of this hardware. Keep in mind this high-quality component is made of durable metal and is sold individually.

This genuine item is supplied by the original equipment manufacturer for use with engines, generators, lawn mowers, lawn tractors, and snowblowers made by Briggs & Stratton, Toro, Lawn Boy, and Murray. The valve guide bushing is made out of metal. It may require a screwdriver and a wrench during installation. This part will need to be replaced if it breaks. This item is sold individually.