Electrolux Freezer Ice Makers

Your Price

$153.41

Electrolux Freezer Refrigerator Ice Maker Assembly

★★★★★

81 Reviews

PartSelect Number PS12364147

Manufacturer Part Number 241798231

This 8-cube ice maker is used to create ice for your refrigerator. The ice maker receives water from the water inlet valve and will freeze until ice cubes are formed. Once the water has been frozen the cubes will be ejected from the mold in to the ice bucket. The ice maker will continue the process until the ice bucket has reached the limit. If your ice maker is not making ice you may need to replace this part. Please remember to disconnect the power and water supply before starting your repair. This ice maker is a genuine OEM part.

Fixes these symptoms

Clicking sound
Ice maker not making ice
Ice maker won’t dispense ice
See more...

Installation Instructions

Juan from Miami, FL

Broken ice maker

Unplugged faulty ice maker, removed two screws holding it to the refrigerator and took it out. Reversed the operation with the new ice maker and after a few minutes presto, we have ice. Read more...

Videos!

Your Price

$105.42

Electrolux Freezer Replacement Ice Maker

★★★★★

28 Reviews

PartSelect Number PS735469

Manufacturer Part Number 5303918277

This replacement icemaker may also be known as the ice maker assembly and is compatible with your refrigerator/freezer. This assembly replaces the heat-release ice maker unit only. The kit comes with four round female connectors at the end of the wire harness. It also comes with the adaptor that converts the harness to three round female, and one round male connectors. The tools you will need in order to make this installation include a 1/4-inch nut driver, and a Phillips screwdriver. Before starting this repair make sure to unplug your refrigerator and shut off the water supply.

Fixes these symptoms

Ice maker not making ice
Ice maker won’t dispense ice
Leaking
See more...

Installation Instructions

JACK from MESA, AZ

Ice Maker Stopped Working

It was pretty straight forward. Remove the two screws that hold the unit to the wall of the freezer. In my case, I had to use a different ice maker than what came with the frig. In order to install the replacement unit they sent a wire adaptor so it would attach to the existing wiring. That too was all fine and dandy. The only problem was that the end of the wire adaptor did not fit through the existing hole in the rear of the frig. I used a utility knife to cut through the thin metal lining. That worked just fine. However, I could not cut through the insulation because I could not reach it through the small hole. The excess wire was supposed to be pulled through the hole and out through the back of the unit. So now the excess is between the wall of the freezer and the insulation. The unit is working wonderfully. In fact, it is making more ice than I can use. I am very pleased with the replacement unit. This is the 3rd ice maker that has been in this frig. All the others had a design flaw that had a leak in the rear of the unit. This caused all the ice to form into a big block. The replacement unit has not had this problem so far. Thank you for allowing me to explain my situation so that maybe others may benifit from my experience. Thank you. Jack Read more...

Your Price

$150.75

Electrolux Freezer Ice Maker Assembly with Water Inlet Valve

★★★★★

6 Reviews

PartSelect Number PS10057479

Manufacturer Part Number IM116000

This add-on icemaker assembly is a part for your refrigerator/freezer. The kit includes an icemaker that makes eight radius ice cubes, the water valve, an ice bucket, the fill tube, the harness, and installation instructions. Note: This icemaker assembly will fit most Frigidaire models manufactured from 2001 to present.

Fixes these symptoms

Ice maker not making ice
See more...

Installation Instructions

MICHAEL from GEORGETOWN, IN

Bought a new refrigerator. Did not come with an Icemaker.

Remove access cover at bottom of case w/socket wrench (4 screws).
Attach supply line to water valve with adjustable wrench. Attach water line to ice maker on back of case (twist lock) no tools required.
Attach water line from ice maker to water valve (push connection) no tools required. Attache water valve to case at bottom w/one screw. (nut driver)
Reassemble access cover to bottom of case w/socket wrench (4 screws). Remove plastic cover inside freezer (w/screw driver to release from evap cover) to expose ice maker harness connection. Remove two plastic plugs (carefully w screw driver) exposing screw anchors for mounting Ice maker. Assemble two mounting screws w/nut driver. (Do not dtrive all the way in) Plug ice maker harness to plug on back of evap cover.(no tools required) Place cover over harness connection) no tools required. Guide water fill tube into fill cup on ice maker. (no tools required) Hang ice maker on mounting screws. Level Ice maker and tighten screws. (torpedo level makes it easy if you have one handy. Place Ice bucket under Ice maker on freezer shelf (lower position). Turn ice maker on and you are ready to go. Easy Job!!!! Read more...

Videos!

Your Price

$21.03

Electrolux Freezer Drive Gear

★★★★★

7 Reviews

PartSelect Number PS2349843

Manufacturer Part Number 5304469403

The ejector drive gear is a part for your refrigerator. This icemaker drive gear is for the ejector blades. The part rotates the cube ejector arm, which cycles the icemaker and pushes the cubes out and into the ice bucket, ready for the ice to be used. The outside diameter of this piece is almost two inches by two inches. The reason for needing to replace your gear is if the current one is broken/missing a tooth, or if your icemaker is not dispensing ice and is noisy.

Fixes these symptoms

Ice maker not making ice
Ice maker won’t dispense ice
See more...

Your Price

$19.39

Electrolux Freezer Ice Maker Shut-Off Lever Cam

PartSelect Number PS2349842

Manufacturer Part Number 5304469402

The ice maker shut-off lever is an OEM replacement part specifically designed to control the production of ice in your refrigerator. It is typically located inside the freezer compartment, near the ice maker. The shut-off lever is responsible for controlling the ice maker functions. When the lever is in the raised position, the ice maker turns off and stops the ice production. Conversely, when the lever is pushed down, the ice maker produces ice cubes. This mechanism allows you to control the ice-making process to suit your needs. A faulty shut-off lever will result in nonstop ice production or no ice production at all. Carefully detach the old lever from its housing and position the new shut-off lever in its place. Finally, reactivate the ice maker and verify that it functions correctly by observing the ice production cycle.

Your Price

$113.21

Electrolux Freezer Ice Container

★★★★★

4 Reviews

PartSelect Number PS430380

Manufacturer Part Number 240385201

The ice bin, located in a freezer, is a storage container used for storing ice. Ice cubes collect there after they are made. If your bin is cracked or damaged, it is best to replace this part. To repair, first open your freezer door and dump any leftover ice residing in bin before removing it. Next, release ice bin from assembly by releasing the locking tabs. With a flathead screwdriver, flex the tabs inwards on each side. Make sure to bend them enough to unlock and pull assembly from the ice bucket. Line up the new ice bin with assembly before installing it. Refer to the manual provided by the manufacturer for further installation instructions.

Installation Instructions

David from VERO BEACH, FL

Missing door shelf

Quick snap Read more...

Your Price

$19.80

Electrolux Freezer ICE STRIPPER

★★★★★

2 Reviews

PartSelect Number PS2349818

Manufacturer Part Number 5304469378

The ice stripper goes on the front of the ice maker and directs the ice cubes from the maker to the bin. Due to the frigid temperatures, the plastic breaks down and cracks from time to time. This may cause the ice cubes to get stuck in the ice maker and not dispense properly. You will need to open the freezer door, pull out the ice container by lifting and pulling out. Unplug the ice maker by releasing the locking tabs. Use your 1/4-inch nut driver to remove the screws holding the ice maker in place. Take the ice maker out of the freezer for easy access. The ice stripper can be removed by simply unlatching from the pin holding it in place. The new ice stripper should just click into place so the tab goes into the control head with ease.

Fixes these symptoms

Ice maker not making ice
See more...

Your Price

$153.91

Electrolux Freezer Icemaker Assembly

★★★★★

9 Reviews

PartSelect Number PS1533004

Manufacturer Part Number 5304458371

This icemaker is used on newer models where the cord will plug directly in to the back of the freezer. It includes the cover, fill cup, bail arm and a four-pin plug harness.

Fixes these symptoms

Ice maker not making ice
Ice maker won’t dispense ice
Leaking
See more...

Installation Instructions

Brenda from Sanford, FL

Did not make ice

First I removed the two screws that hold the element in place. I then pulled the element out about 3 inches and disconnected the two wires. Then I took the new icemaker out of the box and reversed the procedure.

The icemaker is making ice now. Read more...