Electrolux Cooktop Valves

Videos!

Your Price

$17.23

Electrolux Cooktop Left Front Orifice - 9.5K

★★★★★

2 Reviews

PartSelect Number PS2332664

Manufacturer Part Number 316527500

Your Price

$27.05

Electrolux Cooktop Medium Burner - 9.5K

★★★★★

2 Reviews

PartSelect Number PS439737

Manufacturer Part Number 316212400

The surface burner head is used for ranges and ovens, and is located on the cooktop, where the flames go up. The surface burner spreads the gas through holes to create an even flame throughout the entire cooking area. If your surface burner is damaged it can affect the distribution of gas, or the flames may not come up correctly. If this is the case, replace this part. The measurements of the surface burner are: 6.25 inches in length, 5.13 inches in width, 8 inches in height, and 0.4 pounds in weight. Allow your cooktop to cool before installing this part. Refer to the manual provided by the manufacturer for further repair instructions.

Your Price

$16.11

Electrolux Cooktop Surface Burner Orifice

PartSelect Number PS2364100

Manufacturer Part Number 316527509

Sold individually.

Your Price

$43.94

Electrolux Cooktop Sealed Burner - 9.5K

★★★★★

2 Reviews

PartSelect Number PS2364157

Manufacturer Part Number 316558300

Your Price

$18.32

Electrolux Cooktop Right Rear Orifice

★★★★★

1 Review

PartSelect Number PS2349573

Manufacturer Part Number 316527504

Your Price

$24.47

Electrolux Cooktop Burner Orifice - 12K

PartSelect Number PS2349572

Manufacturer Part Number 316527502

Your Price

$67.33

Electrolux Cooktop Sealed Burner Head - 14k

★★★★★

2 Reviews

PartSelect Number PS820297

Manufacturer Part Number 316223400

Fixes these symptoms

Gas igniter glows, but will not light
Will Not Start
See more...

Installation Instructions

Roland from Auburn, ME

The burner would not light by itself, and the flame was lopsided.

The repair was nothing, but the diagnosis was a bit tricky. After carefully looking at the burner head, (cast aluminum) I pretty much figured out that the 4 small cast aluminum bumps that keep the burner cap positioned up in the air the correct amount to allow gas to flow under the cap, were worn down, preventing the gas from exiting properly by the igniter. My guess was correct. The new burner head solved all my problems. I love Parts Select for the ease of finding the correct parts and how fast they ship their orders. Great company, great service. Keep up the good work Read more...