Edger Handles

This is an OEM replacement part, it is sold individually. The Throttle Trigger controls the speed of the engine of the models listed below. The throttle cable connects to the trigger, then down to the throttle lever on the carburetor. Because of its constant use the Throttle Trigger has a tendency to break or wear out.

This throttle trigger is an OEM direct from the Echo manufacturer. The poly plastic part is compatible with several edgers and trimmers. The trigger is fastened to the control handle assembly and the trigger spring, allowing the operator to manage the amount of fuel flow to the engine. This part is sold individually. For the repair, you will need a screwdriver and a pair of pliers.

Genuine Echo replacement part, this item is sold individually This is the part of the outdoor products listed below that controls the speed of the engine by pressing it or releasing it. The throttle cable connects to this part and then down to the carburetor.

This replacement throttle housing is specially designed for use with Husqvarna trimmers and edgers. It is an authentic OEM sourced part, not an aftermarket imitation. This is the left hand side plastic housing piece only. Please note, the right hand side housing piece and the hardware to secure the two pieces together are all sold separately. To complete this repair you will need a screwdriver.

This is an authentic OEM part used in the Husqvarna trimmers listed below. This is the main trigger throttle mechanism attached to lower part of handle. While disassembling handle for this repair, be sure to separate pieces carefully so that no springs are lost. Note detailed positioning of all parts before removing them; proper positioning is vital to tool functioning. Sold individually. Throttle trigger spring is available separately, as part # 530016454. Note that this trigger fits serial number 2010-73N and higher. For lower serial number models, see trigger part # 545066001.

This plastic part is genuine OEM and is used in various DeWALT and Black & Decker edgers. This is a two (2) part handle. Each half attaches together with Torx T20 head screws. It houses a trigger switch, power cord, and protector cord at one end and an upper tube at the other end. The black auxiliary handle (sold separately) is attached to top front of this orange handle. Sold individually.

This is a genuine OEM sourced part which is specially designed for Husqvarna trimmers and edgers. It is an identical replacement for a missing or a damaged handle assembly that was installed on a new unit. The handle provides a user with a comfortable grip to operate the unit. It also houses the switch which controls the throttle. Keep in mind this high-quality handle assembly is sold as an individual item. Please make sure to refer to the appropriate diagrams for your model to ensure the proper repair procedure. A screwdriver and pliers might be needed to replace this handle assembly.

This authentic manufacturer approved replacement part that is specially designed for use with Echo handheld trimmers/edgers. This trigger allows user to turn the unit on and off and control it\'s speed. It is made out of plastic and it is sold individually. To complete this repair you would need a screwdriver. • Remove screws securing the housing • Remove the old trigger (keep the springs) • Secure the new trigger • Reassemble and test the unit

This replacement throttle housing is a high quality OEM item that is specially designed for Husqvarna string trimmers and edgers. This is the right hand side plastic housing piece, please note that the left hand side piece and the hardware to secure the two halves are all sold separately. To complete this repair you will need a screwdriver.

Genuine Echo replacement part, this item is sold individually. This is part of the safety start system on all of the trimmers listed below. This part is installed on the top handle and has to be pressed down while pulling the starter rope in order for the engine to start.