Echo Engine Bearings

This single-row, deep-groove ball bearing is sized at 12x32x10mm and is made of durable metal. It is used to reduce friction and vibrations when it is in between two parts that are rotating or moving against each other. This bearing can handle forces that are applied to it up-and-down and sideways, also known as radial and axial loads. It is easy to install and can handle high rotational speeds without causing too much vibration or making much noise. Over time, this ball bearing wears out from heat and pressure and starts to fail. If the engine of your machine has been run without oil in the gas tank, this ball bearing can seize. In these situations, you will need to replace the ball bearings. Otherwise, you will notice that your machine overheats, works harder because of the increased friction it is handling, and produces excessive vibration and noise. To extract a ball bearing from your machine, you will need to insert a flat-head screwdriver through the bearing opening and against the seal. Then, tap the seal out with a mallet. Afterwards, slot a socket through the diameter of the bearing, and tap the entire bearing out of its place by again using a mallet. This authentic OEM part is sold individually, so be sure to refer to your user manual to verify how many bearings your machine needs and where they are in it.

This silver metal Ball Bearing is manufacturer certified, and used to reduce the friction between parts, and comes individually sold. If broken or worn down, you will hear a grinding, growling, stretching, or rumbling sound, and the part should be replaced. Installing this new part requires a bearing puller. Refer to your make, model and diagram to check if this is the right part.

This authentic replacement part is designed for use with Echo and Shindaiwa equipment. Ball bearings are used to reduce friction between rotating parts. The rollers take the load and spin, distributing the weight evenly while the minimal contact area of the ball reduces friction. Over time components tend to wear out and may begin to fail eventually requiring a replacement. Please note this high-quality metal bearing is sold individually.

This is an original replacement part sourced from the Echo manufacturer. The bearing-ball is constructed of high-quality metal, and is compatible with many brushcutters and trimmers. Two bearing-balls are most often secured between the snap ring and the fan cover. Keep in mind this item is sold individually. It is also recommended to refer to the device manual for specific repair instructions. A wrench and a screwdriver are needed to make the removal and replacement.