Dyson Parts

Dyson Switch This part is an OEM from the Dyson manufacturer. The metal and plastic switch is made for use with several upright vacuums. This item is fastened inside the switch cover assembly, allowing the operator to (de)activate the engine. The switch is sold individually, and a screwdriver is needed for the installation.

Dyson Soleplate Wheel This is a genuine OEM sourced part is specially designed for Dyson upright vacuums. It is an important component that helps to support the soleplate. Over time it may wear out, get damaged or lost eventually requiring a replacement. Make sure to refer to the appropriate diagrams for your model to ensure the correct repair procedure. Note, this high-quality soleplate wheel is sold as an individual component. A screwdriver will be needed to replace this part.

Dyson Internal Hose Assy The internal hose attaches to the iron/titanium cleaner head. This is an authentic part from Dyson for use in upright vacuums. This item is available as an individual replacement part. A screwdriver might be necessary during the installation of this item. It is made of plastic and will require replacing if it becomes broken.

Dyson Silver Tool Catch This part comes directly from Dyson. This Tool Catch is used in multiple models of Dyson vacuum cleaners. The Tool Catch locks the tools and attachments onto the vacuum. This part is made of plastic. The Tool Catch should be replaced when it no longer holds the tools securely or if it has become damaged in any way. To replace the Catch you will need to use a couple of screwdrivers to gently pry the old part out of the tabs. The new Catch is simply installed by pushing it into the recess until it clips into place.

Dyson Internal Hose Assy This internal hose assembly is an OEM part direct from Dyson. The metal and plastic assembly is made for use with several vacuums, and is sold individually. A screwdriver and pliers are needed for the proper replacement. Please refer to the manual for further repair instructions.

Dyson Exhaust Pre-filter Seal This is a high-quality replacement for a missing or a faulty o-ring that was installed on a new unit. It is designed for use with Dyson upright vacuums. The part helps to provide an air-tight seal for the exhaust pre-filter. Seals over time may wear out and eventually will need to be replaced. Note, one high-quality rubber part is included. Check the owners manual and the appropriate diagram of your specific model for the exact location and application of this component.

Dyson Bin Seal

Dyson Axle

Dyson Valve Carriage Seal

Dyson Clutch Belt This is an original Dyson replacement part manufactured for use with upright vacuums. This is the motor to clutch belt, it is important to clean the clutch, and motor shaft when replacing the belt, the belt is sold individually.