Craftsman Edger Control Cables

Craftsman Edger Throttle Cable This throttle cable is responsible for controlling the engine speed in edgers. It is a manufacturer-approved cable designed with specific end fittings that connect to the throttle control lever on one end and the carburetor on the other. When the throttle control lever is adjusted, the cable transmits the motion to the carburetor, which allows the user to regulate the engine speed. Over time, the throttle cable can wear out, fray, or become disconnected, leading to loss of throttle control, lower power output, and engine stalling. To replace the throttle cable, first ensure the engine is off and cool, for your safety. Locate the end fittings on the cable and disconnect them carefully. Remove the fasteners that secure the cable, and then route the new cable along the same path as the old one. Finally, reconnect the end fittings, and adjust the cable tension as necessary.

Craftsman Edger Wheel Adjust Cable This wheel adjustment cable is used for both lawn edgers and trimmers and measures 32.75-inches in length. Featuring a metal cable insulated with rubber, this cable is used to raise or lower the blade within your equipment to control the cutting depth and is connected to a lever near the handle. Depending on your model, the installation instructions may vary, so check your user manual or any relevant diagrams for assistance.

Craftsman Edger Cable Guide

Craftsman Edger Throttle Assembly

Craftsman Edger Tensioner Cable Assembly

Craftsman Edger Ground Cable

Craftsman Edger Bail Oper.cntrl.(vert

Craftsman Edger Cable-throttle