Compressor Tanks and Containers

This OEM sourced replacement gauge is designed for use with Rolair compressors. The gauge registers pressure readings and allows you to maintain needed pressure. This gauge is sold individually. You would need a wrench to secure this gauge to the manifold. When replacing this item make sure to unplug the air compressor and bleed out air from the tank.

This is an Genuine OEM replacement part used on Air Compressors. The gauge registers pressure readings and allows you to maintain needed pressure. This Gauge is Sold Individually. You would need a Wrench to secure this Gauge to the Manifold. When replacing this item make sure to unplug the air compressor and bleed out air from the tank.

This tank pressure gauge shows how much compressed air is stored inside the compressor tank. Its 2-inch dial makes the pressure easy to read during use. Replace the gauge if the lens is broken, the needle sticks, or air leaks near the fitting. Before ordering, check the pressure range, 13 mm back connection, thread type, and full compressor model. Unplug the compressor and drain the tank to zero pressure before service. Use only approved thread sealant, tighten the fitting without twisting the gauge body, and check for air leaks before normal use.

This is an OEM replacement part for SprayTECH and Wagner airless paint sprayers. The hopper is designed to fit on the machine and hold excess paint to feed into the pump. The hopper is made of durable material. This item is sold individually.