Compressor Legs and Feet

This is a genuine OEM sourced replacement isolator foot that help to keep you air compressor stable and also help to minimize the vibration. This item is made out of rubber with metal and it is sold individually. Please note the screw used to attach it is sold separately. You would need a wrench to replace this item.

This rubber isolator foot helps reduce vibration and noise generated by an air compressor while providing a stable, non-slip base during operation. Constructed from durable hard rubber with an integrated metal core, it absorbs motor vibration and helps prevent the compressor from shifting or "walking" across the floor, protecting both the equipment and the supporting surface. Replacing a worn, cracked, flattened, or damaged isolator foot can restore stability, improve vibration dampening, and help extend the life of the compressor by reducing stress on the frame and mounting components. This replacement foot is sold individually and includes the mounting screw required for installation. Installation is straightforward and typically requires only a screwdriver to remove the old foot and secure the replacement in place. For best results, inspect the remaining feet and mounting hardware for wear or damage and replace additional components as needed to maintain proper compressor stability and support.

This replacement rubber foot is an authentic item that is supplied by original equipment manufacturer for use with Rolair compressors. It is secured on the bottom to keep the unit stable while minimizing the vibrations from a working engine. This item is made of durable rubber and it is sold individually, please note the hardware to secure it is sold separately.

This rubber foot is genuine OEM, guaranteed to fit Rolair compressors listed below. These anti-vibration feet are an important part of dampening the machine's sound. Since sound reduction only occurs if all feet are attached, owning a few backup feet is recommended. This repair does not require any tools; just push the part into place. Includes one (1) foot.

It is an authentic OEM sourced item that is specially designed for use with Bostitch air compressors. This rubber foot is secured to the frame helping to keep the unit stable and minimize the vibrations while the compressor is on. One durable rubber foot is included per order, please note the hardware to secure it is sold separately.

Genuine Bostitch replacement part, it is sold individually. The purpose of the Rubber foot is to cushion and keep the compressor models below from moving when in operation. It is secured to the compressor by using part numbers AB-9412016 Washer and AB-9101315 Screw.

This is an authentic OEM sourced part which is specially designed for Rolair air compressors. It is an identical replacement for a missing or faulty foot that was installed on a new unit, please make sure to refer to the appropriate diagrams of your model for the correct location and application of this hardware. Keep in mind this high-quality foot is made of durable rubber and is sold individually.

This is an authentic replacement piece for the Makita compressors listed. Rubber foot attaches to base of the compressor frame, dampening vibrations and sound while stabilizing the compressor. This assembly includes one (1) each of: foot, washer, and screw. Each piece is not sold separately and are only available in this set.