Chainsaw Switches

Chainsaw Lawn Mower Power Take-off Switch

★★★★★

★★★★★

1 Review

This item is sourced from the original manufacturer. It is an authentic part used with riding lawn tractors/mowers. This is the switch that allows user to engage blades. To stop mower blades, place attachment clutch control in the "DISENGAGED" position. One (1) plastic switch is included per order. Mechanical switches tend to break with time, eventually requiring replacement. This is standard 8 terminal black switch. Replacing this switch is a simple task. • Make sure to disconnect spark plug • Once you gained access under the housing disconnect wires • Remove old switch by pushing on side tabs • Secure new PTO switch • Reconnect wires and spark plug • Test the unit

Chainsaw Lawn Mower Interlock Switch It is a genuine manufacturer-approved part which is specially designed for Ryobi and Husqvarna riding lawn mowers and garden tractors. The purpose of the switch-interlock is to act as a safety feature which will shut the engine off when equipment is started or running in unsafe operating conditions. Unfortunately, over time parts will wear out and it may begin to fail eventually requiring a replacement. Refer to the owner\'s manual and the appropriate diagrams for your model for the correct location and installation of this component. Note, this high-quality plastic body interlock switch is sold individually. You will need a screwdriver to perform this repair.

Chainsaw Switch Assembly

Chainsaw Stop Switch This switch is specially designed to stop the engine when you move it to the stop position/setting. It is an authentic replacement item that is supplied from original equipment manufacturer for use with Husqvarna chainsaws. Includes one (1) switch per order. To replace this stop switch you will need a screwdriver. • Make sure to disconnect spark plug and drain fuel • Remove screws from the housing • Separate housing pieces • Disconnect wires from the old switch • Secure new stop switch in place • Reconnect the wires • Reassemble and test the new switch

Chainsaw Variable Speed Switch

Chainsaw Switch-single Pole No This part is sold individually and is made of plastic and metal. The single pole switch connects to the wiring harness. A set of pliers may be required to replace this part if it becomes broken. It is a genuine OEM sourced part which is specially designed for use with Toro and Lawn Boy for use in lawn tractors and riding mowers.

Chainsaw Start/stop Switch This is an original replacement part manufactured for use with trimmers. The start/stop switch is also called the kill switch, and fits on the upper handle above the throttle. The red switch is used to shut of the engine, and has to be engaged to run the engine. The switch is sold individually.

Chainsaw Pcb Switch

Chainsaw Switch Asm The switch assembly goes next to the rocker switch and is made of metal. This is sold as a kit that contains the switch, the nut, and the lockwasher. These are OEM parts from Toro and Lawn Boy for use in lawn tractors. If these items become broken they will need to be replaced and may require a wrench during the installation.

Chainsaw Stop Switch This red and black OEM switch is an important component of your handheld lawn and garden equipment, allowing you to easily turn it on or off. The specific location of the switch can vary depending on the model and make of your machine, so it is advisable to consult your user manual for guidance. As the switch is used over time, it can wear out and potentially fail. If the switch is broken, you will not be able to start your machine, and you must replace it immediately. To remove the switch, you will require either a screwdriver or needle-nose pliers. If the switch housing is secured with fasteners, unscrew them first. Then carefully pry the switch out of its housing and disconnect the attached wires. Please note that this switch is sold individually.